iMedia Receiver with Video & Mic Input Crestron IM-RXV1-M & IM-RXV3-M
The iMedia Transport
The iMedia transport utilizes a single CAT5e* type cable to transmit computer RGB,
video, and stereo audio signals to a single display device. A typical XGA signal
(1024 X 768 pixels at 60 Hz) can be transmitted up to 84 feet using iMedia, while
higher resolutions up to 1600 x 1200 can be handled over shorter distances.
Composite video signals can be transmitted up to 218 feet. Audio is transmitted
digitally at 20-bit, 48 kHz resolution. Control and power signals are also contained
on the same wire, eliminating the need for separate control or power cables.
* For iMedia use CresCAT-IM cable, or quality CAT5e/CAT6 cable having a maximum delay skew of
15ns per 100m.
iMedia Recevier
Mounted at the display device, the IM-RXV1-M and IM-RXV3-M receive the
iMedia signal from up to three IM transmitters, breaking out the RGB, video, audio,
and control signals for connection to the display device. Adjustable bandwidth
compensation is provided to maximize image quality over long cable runs.
Integrated Amplifier
The IM-RXV1-M and IM-RXV3-M include a built-in 20 watt stereo amplifier to
drive a pair of 8 ohm speakers. Balanced line level outputs are also provided to allow
the audio signal to be connected directly to inputs on the display device or fed to a
pair of powered speakers. Onboard digital signal processing affords adjustment of
audio levels, plus bass, treble, and balance settings at setup via software.
Wireless Microphone Input
The inclusion of a balanced line input allows the connection of a wireless
microphone receiver, audio mixer, or mic preamp to support speech reinforcement
capabilities. Microphone level is adjustable right at the IM transmitter by holding the
SELECT button and turning the VOLUME knob.
Display Control
The IM-RXV1-M and IM-RXV3-M contain both IR and bidirectional RS-232 ports
to enable full control of the display device. Two relay ports are also included for
control of a projection screen or lift. In addition, the three digital input ports can
accept the direct connection of room occupancy sensors and power sensors for
enhanced automation and monitoring.
e-Control®2 and RoomView®
Despite their simple design and low cost, the IM-RXV1-M and IM-RXV3-M support
Crestron's powerful e-Control 2 XPanel and RoomView applications, delivering the
industry's best help desk and resource management solution for any number of rooms
equipped with iMedia.
Fast, Easy Setup
System setup takes mere minutes using iMedia Wizard software, providing easy
start-to-finish configuration, adjustment, and documentation.
Crestron IM-RXV1-M & IM-RXV3-M iMedia Receiver with Video & Mic Input
Applications
The IM-RXV1-M and IM-RXV3-M are part of the Crestron® iMedia line of network
devices, room control systems and signal routing solutions. The line of iMedia
devices includes receivers and transmitters. Consult the Crestron website
(http://www.crestron.com/) for a complete and current listing of the iMedia product
line.
NOTE: The composite video output of the IM-RXV1-M and IM-RXV3-M are not
enabled when using the iMedia transmitters without composite video inputs.
The IM-RXV1-M and IM-RXV3-M can be placed on a table or mounted to a surface
using the included brackets. These receivers can also be mounted to a pipe using the
optional pole mount kit MK-IM-RX.
NOTE: The IM-RXV1-M and IM-RXV3-M are not Cresnet
The IM-RXV1-M and IM-RXV3-M are part of a family of compatible iMedia
devices, all capable of working together to put on simple to complex media
presentations. The following diagrams show the IM-RXV1-M and IM-RXV3-M in
typical one-room installations.
IM-RXV1-M in a Typical Installation for Media Presentation
1024 x 768 @ 60 Hz with maximum cable
length of 84 feet, 1600 x 1200 @ 60 Hz
with maximum cable length of 34 feet; refer
to “Video Resolution and Cable Length” on
Page 13 for other resolutions
0 dB (75 ohm termination)
480i (NTSC), 576i (PAL)
Crestron IM-RXV1-M & IM-RXV3-MiMedia Receiver with Video & Mic Input
IM-RXV1-M & IM-RXV3-M Specifications (Continued)
SPECIFICATION DETAILS
Audio
D-A Conversion
Bass/Treble Gain Range
Frequency Response
S/N Ratio
THD+N
Ethernet
Power Requirements 3 Amps @ 18 Volts DC
Environmental
Temperature 41º to 104ºF (5º to 40ºC)
Humidity
Thermal Dissipation
Enclosure
Dimensions
Height 1.62 in (4.10 cm)
Width 8.75 in (22.23 cm)
Depth 7.69 in (19.53 cm)
Weight 1.75 lbs (0.80 kg)
Included Accessories
PW-1830RU
Available Accessories
MK-IM-RX
CNSP-XX
IRP2
CNXRMCS
20-bit, 48 kHz
±12 dB
20 Hz to 20 kHz ±0.5 dB (line),
20 Hz to 20 kHz ±1 dB (speaker)
82 dB (line), 80 dB (speaker) 20 Hz to
20 kHz A-weighted
0.05% (line), 0.7% (speaker) 20 Hz to
20 kHz
10/100 BaseT, static IP or DHCP/DNS,
auto-negotiating, built-in Web server,
supports Crestron e-Control 2 XPanel and
RoomView applications
10% to 90% RH (non-condensing)
100 BTU/Hr
Black metal; freestanding, surface mount
using "L" brackets provided, or pole mount
using optional pole mount kit
(sold separately)