Crestron electronic CLSI-C6, CLSI-C6M User Manual

Crestron CLS/CLSI-C6 & CLS/CLSI-C6M iLux™ Lighting System

™

ilux

Lighting System:

CLS/CLSI-C6 & CLS/CLSI-C6M

Purpose

The purpose of this addendum is to provide correction to a diagram and provide
additional information not supplied with the latest version of the CLS/CLSI-C6/C6M
Operations Guide (Doc. 6347). Specifically, this addendum:

•

Corrects the hardware hookup diagram on page 11.

•

Adds a note on page 16 defining which load types to choose when
using expansion modules.

Correction of Hookup Diagram

The following diagram replaces the one that follows the paragraph on page 11
describing hardware hookup procedures. The diagram removes specific rating
information for the circuit breaker supplying power to the iLux unit, and instead
refers to the specifications to determine the appropriate rating. The diagram also
includes information on the use of extension modules with the units.

Addendum #1 for DOC. 6347B ilux™ Lighting System: CLS/CLSI-C6 & CLS/CLSI-C6M • 1

iLux™ Lighting System Crestron CLS/CLSI-C6 & CLS/CLSI-C6M

Addition of Note

Add the following at the beginning of page 16. The note defines the selection of load
types when using expansion modules as loads on an iLux lighting system.

NOTE: When using an expansion module for dimmed loads, choose the
Incandescent load type; for non-dimmed loads, choose Non-dim.

NOTE: For some expansion modules, low-end levels can be set either on the iLux
unit or directly on the expansion module.

Crestron Electronics, Inc. Addendum #1 for DOC. 6347B

15 Volvo Drive Rockleigh, NJ 07647 05.08
Tel: 888.CRESTRON
Fax: [phone] Specifications subject to
www.crestron.com change without notice.