Crestron PMK-2000L User Manual

Pre-Construction Mount Kit: PMK-2000L

The PMK-2000L is a pre-construction mount kit that has been developed for the Crestron
Isys™ TPS-2000L, compact video touchpanel. Refer to the physical views (top, side, and
front) of the PMK-2000L, shown below.

PINS USED WITH
OPTIONAL MMK-2000L

TOP

VIEW

SIDE
VIEW

0.060 in

(0.152 cm)

THICK

FOR DRYWALL

NAIL

FOR DRYWALL

SCREW

FOR DRYWALL
NAIL OR SCREW

FOR DRYWALL

SCREW

FOR DRYWALL

NAIL

2.406 in

(6.111 cm)

5.820 in

(14.783 cm)

#4-40 TAPPED HOLE (4 PLACES)
SCREWS SUPPLIED WITH TOUCHPANEL

CUTOUT

DIMENSIONS

7

inches

4

16

5

6

16

inches

21

inch

32

STUD

OFFSET

FRONT

VIEW

0.342 in

(0.879 cm)

5.086 in

(12.918 cm)

SECURE 18 AWG

BUS WIRE IN

NOTCH TO HANG

CABLES AWAY
FROM DRYWALL
CUTTING TOOLS.

NOTE:

PRE-CONSTRUCTION

PLATE MUST BE

LEVEL BEFORE

APPLICATION OF

SHEET ROCK

STUD

PMK-2000L

ASSEMBLED

VIEW

6.60 in.

(16.76 cm)

COVER PLATE

INSTALLED

4.65 in.

(11.81 cm)

Assembled View

The PMK-2000L consists of a single metal plate, shown above, which can be fastened to the
stud of a framed wall prior to hanging drywall. The plate is designed to provide the necessary
support for a single touchpanel and can mount to the right or left side of a stud. Confirm that
the PMK-2000L is level before application of sheet rock. Refer to “Assembled View”, shown
above. The PMK-2000L includes an 18 AWG bus wire to secure touchpanel cabling during
drywall installation and to avoid damaging the cables when the opening is routed.

A rectangular opening with the dimensions shown above must be made in the drywall. Verify
that the opening exposes the #4-40 tapped holes in each corner. If the opening for the
touchpanel in the drywall is too large, two pre-construction accessories are available to make
adjustments. Use the optional TMK-2000L (Trim Ring Kit) to provide a smooth edge at the
opening. This option provides a finished appearance and is preferred when wallpaper is
hung. Use the optional MMK-2000L (Mud Ring Kit) to fill in larger irregularities around the
opening (requires plastering). Standard drywall nails or screws to attach the PMK-2000L are
not supplied (length can vary). Complete the installation by either installing the touchpanel,
leaving the hole open (if permitted by local building codes), or installing the supplied cover
plate with #4-40 x 1

1

/2” screws. Refer to “Cover Plate Installed” view, shown above.

Further Inquiries

If after reviewing this sheet, you cannot locate specific information or have questions, please
take advantage of Crestron's award winning customer service team by calling:

• In the US and Canada, call Crestron’s corporate headquarters at
1-888-CRESTRON [1-888-273-7876].

• In Europe, call Crestron International at [phone].

• In Asia, call Crestron Asia at [phone].

• In Latin America, call Crestron Latin America at [phone].

Crestron Electronics, Inc. Installation Guide – DOC. 6018A

15 Volvo Drive Pre-Construction Mount Kit: PMK-2000L
Rockleigh, NJ 07647 07.03
Tel: 888.CRESTRON Specifications subject to change without notice.
Fax: [phone] www.crestron.com

• In Australia and New Zealand, call Crestron Pacific at [phone].

Return and Warranty Policies

Merchandise Returns / Repair Service

1. No merchandise may be returned for credit, exchange, or service without prior
authorization from CRESTRON. To obtain warranty service for CRESTRON
products, contact the factory and request an RMA (Return Merchandise
Authorization) number. Enclose a note specifying the nature of the problem,
name and phone number of contact person, RMA number, and return address.

2. Products may be returned for credit, exchange, or service with a CRESTRON
Return Merchandise Authorization (RMA) number. Authorized returns must be
shipped freight prepaid to CRESTRON, Cresskill, N.J., or its authorized
subsidiaries, with RMA number clearly marked on the outside of all cartons.
Shipments arriving freight collect or without an RMA number shall be subject to
refusal. CRESTRON reserves the right in its sole and absolute discretion to
charge a 15% restocking fee, plus shipping costs, on any products returned with
an RMA.

3. Return freight charges following repair of items under warranty shall be paid by
CRESTRON, shipping by standard ground carrier. In the event repairs are found
to be non-warranty, return freight costs shall be paid by the purchaser.

CRESTRON Limited Warranty

CRESTRON ELECTRONICS, Inc. warrants its products to be free from
manufacturing defects in materials and workmanship under normal use for a period
of three (3) years from the date of purchase from CRESTRON, with the following
exceptions: disk drives and any other moving or rotating mechanical parts, pan/tilt
heads and power supplies are covered for a period of one (1) year; touchscreen
display and overlay components are covered for 90 days; batteries and incandescent
lamps are not covered.

This warranty extends to products purchased directly from CRESTRON or an
authorized CRESTRON dealer. Purchasers should inquire of the dealer regarding the
nature and extent of the dealer's warranty, if any.

CRESTRON shall not be liable to honor the terms of this warranty if the product has
been used in any application other than that for which it was intended, or if it has
been subjected to misuse, accidental damage, modification, or improper installation
procedures. Furthermore, this warranty does not cover any product that has had the
serial number altered, defaced, or removed.

This warranty shall be the sole and exclusive remedy to the original purchaser. In no
event shall CRESTRON be liable for incidental or consequential damages of any
kind (property or economic damages inclusive) arising from the sale or use of this
equipment. CRESTRON is not liable for any claim made by a third party or made by
the purchaser for a third party.

CRESTRON shall, at its option, repair or replace any product found defective,
without charge for parts or labor. Repaired or replaced equipment and parts supplied
under this warranty shall be covered only by the unexpired portion of the warranty.

Except as expressly set forth in this warranty, CRESTRON makes no other
warranties, expressed or implied, nor authorizes any other party to offer any
warranty, including any implied warranties of merchantability or fitness for a
particular purpose. Any implied warranties that may be imposed by law are limited
to the terms of this limited warranty. This warranty statement supercedes all previous
warranties.

Trademark Information

All brand names, product names, and trademarks are the sole property of their respective owners.
Windows is a registered trademark of Microsoft Corporation. Windows95/98/Me/XP and
WindowsNT/2000 are trademarks of Microsoft Corporation.