Operations & Installation Guide – DOC. 6349A Contents • i
Crestron IM-FTCC-B iMedia FlipTop Computer Center
iMedia FlipTop Computer
Center: IM-FTCC-B
Introduction
Features and Functions
Installs flush in a tabletop surface
Convenient cable storage
One AC power pass-through
One iMedia RJ-45 output connector (on the bottom side)
Power on/off SELECT button and indicator
Rotary local volume control
Lid flips open 180 degrees for easy access
Includes cable management kit with VGA and audio cables
Cutout template provided
Available in both domestic (IM-FTCC-B) and international
The IM-FTCC-B/IMI-FTCC-B is part of the Crestron® iMedia line of network
devices, room control systems and signal routing solutions. The line of IM
devices includes receivers and transmitters. Consult the Crestron website for a
complete and current listing of the iMedia product line.
NOTE: Composite video output of the IM-RXV1 and IM-RXV3 will not be
displayed when using the IM-FTCC-B/IMI-FTCC-B.
The iMedia FlipTop Computer Center is designed to install flush in a tabletop
surface to provide a convenient and low profile interface solution. Beneath the
flip-top lid, a recessed compartment contains easy pull-out RGB and audio
cables to facilitate the connection of a single computer source. The cables stow
neatly within the compartment when not in use. Excess cable simply drops outof-sight below the box through grommeted holes provided in the bottom plate.
An additional hole is available to accommodate a third-party LAN cable if
needed. A cutout template is included.
NOTE: The IM-FTCC-B and IMI-FTCC-B are not Cresnet
This device uses iMedia (IM) technology utilizing a single CresCAT-IM cable
to transmit computer RGB and stereo audio signals to a single projector or
plasma display. A typical XGA signal (1024 X 768 pixels at 60 Hz) can be
transmitted up to 84 feet using iMedia, while higher resolutions up to
1600 x 1200 can be handled over shorter distances. Audio is transmitted
digitally at 20-bit, 48 kHz resolution. To facilitate connection of audio, video,
and computer equipment, all media, power and control signals are routed via a
single CresCAT-IM cable for an uncomplicated installation.
The IM-FCC-B is part of a family of compatible iMedia devices, all capable of
working together to put on simple to complex media presentations. The
following diagram shows the interconnections.
Specifications for the IM-FTCC-B/IMI-FTCC-B are given in the following
table.
IM-FTCC-B/IMI-FTCC-B Specifications
SPECIFICATION DETAILS
Video Formats RGBHV (VGA), RGBS, RGsB
RGB Video
Resolutions
H and V Sync 5 V
Computer Associated
Audio
Max. Line level input 2 V
Input Impedance 10 K Ohm
Audio Analog/Digital
conversion
Frequency Response 20 Hz to 20 kHz
Operating Temperature
and Humidity
Dimensions and Weight
(IM-FTCC-B)
Dimensions and Weight
(IMI-FTCC-B)
International Adaptors for
IMI-FTCC-B Models
R/G/B: 0 dB (Unity gain, 75 Ohm termination), for
1.0 V
Supports videos up to XGA @ 60 Hz vertical rate
with maximum cable length of 84 feet and
maximum compensation at receiver. For higher
pixel resolutions (up to 1600 X 1200 pixels at
60 Hz vertical rate) refer to the chart on page
20-bit, 48 kHz
41º to 104º F (5º to 40º C)
10 to 90% relative humidity (non-condensing)
Width: 6.84 in (17.38 cm)
Height: 4.63 in (11.76 cm) With Lid Closed
Depth: 5.62 in (14.28 cm) Without Mounting
Brackets
Weight: 3.65 lbs (1.66 kg) With Cables
Width: 8.34 in (21.18 cm)
Height: 5.43 in (13.79 cm) With Lid Closed
Depth: 6.20 in (15.74 cm) Without Mounting
Brackets
Weight: 4.42 lbs (2.01 kg) With Cables
Refer to Appendix on page 21.
max input. Input Impedance 75 Ohms.
p-p
max into 1 K Ohm
p-p
RMS
12.
Physical Description
Beneath the flip-top lid, a recessed compartment contains RGB and audio cables
to facilitate the connection of a single computer source. The recessed
compartment also contains the AC outlet and the SELECT button. Refer to the
following physical views.