Crestron CAEN-MK User Manual

Crestron CAEN-MK
CAEN Mounting Kit
Installation Guide

This document was prepared and written by the Technical Documentation department at:

Crestron Electronics, Inc.

15 Volvo Drive

Rockleigh, NJ 07647

1-888-CRESTRON

All brand names, product names and trademarks are the property of their respective owners.

©2003 Crestron Electronics, Inc.

Crestron CAEN-MK CAEN Mounting Kit

)

CAEN Mounting Kit: CAEN-MK

Description

The CAEN-MK is a mounting kit required for the installation of the Crestron
C2N-NPA8 Network Poll Accelerator or the C2N-SPWS300 Power Supply in any
CAEN enclosure. The table below lists all parts included with the CAEN-MK.

Supplied Components

DESCRIPTION PART NUMBER QUANTITY

Metal Bracket MTBK02856-1 1
Metal Bracket MTBK02857-1 1

Screw, 08-8B, 1/4" L, pan phillips SR08-8B-0R2500-1 4

Nut, KEPS, 08-32 NT08-32-2 4

Terminal Block, 1 Pos,

DIN Rail, 22-10 AWG, Wht

Terminal Block, 1 Pos,

DIN Rail, 22-10 AWG, Blk

Terminal Block, Hdw, End Bracket JTHWXX-1 1

Terminal Block, Hdw, End Plate JTHWXX-2 1

Terminal Block, Hdw, Partition Plate JTHWXX-3 1

JTTB01-4 1

JTTB0106 1

NOTE: This mounting kit may also be used for future devices.

The front view of a C2N-SPWS300 mounted on a CAEN-MK is shown in the
following diagram.

C2N-SPWS300 shown with CAEN-MK Attached

0.90 in

(2.29 cm)

6.00 in

(15.24 cm)

14.00 in

(35.56 cm)

Installation Guide - DOC. 6130 CAEN Mounting Kit: CAEN-MK • 1

0.50 in

(1.27 cm)

7.00 in

(17.78 cm

CAEN Mounting Kit Crestron CAEN-MK

Installation

Assembly

Tools/hardware required

11/32” Wrench or nut driver

8-32 Nuts (quantity four, supplied)

Complete the following assembly procedure in the order provided (refer to
illustration below).

1. Holding the device facing you, position the bracket-mounting studs on
metal bracket MTBK02857-1 in the device’s mounting holes as shown
in the following diagram.

2. Slide the metal bracket through the device’s mounting holes.

3. Using an 11/32” wrench, secure the two nuts (supplied) to the
mounting studs on the metal bracket.

4. Repeat for the other bracket.

Assembly View

NUTS, KEPS
8-32

METAL BRACKET
(MTBK02856-1)

METAL BRACKET
(MTBK02857-1)

2

• CAEN Mounting Kit: CAEN-MK Installation Guide - DOC. 6130

Crestron CAEN-MK CAEN Mounting Kit

Mounting

NOTE: This assembly must be installed in accordance with local building codes.

Tools/hardware required

#2 Phillips tip screwdriver

8B x ¼”L Self-tapping screws (quantity four, supplied)

Flat tip screwdriver (optional)

Complete the following procedure (refer to illustration below) to mount the
assembly.

1. Position the assembly to be mounted in front of an available space in a
Crestron CAEN enclosure (at the bottom of a single-width enclosure or
across two side-by-side spaces in a double-width cabinet) to determine
the location of the mounting holes. After determining the position,
remove the assembly and continue to step 2.

2. Remove any required knockouts to route any required wiring outside of
the enclosure.

3. Using a #2 Phillips tip screwdriver, install four screws (supplied) half
way into the CAEN enclosure.

4. With the assembly in hand, position the large portion of the left
bracket’s keyholes over the screws on the left side of the installation
location. Hold the unit flat against the back plane of the CAEN
enclosure, and slide the slotted portion and right-hand brackets under
the screw heads.

5. Tighten the four screws to secure the assembly to the enclosure.

Install Assembly into CAEN

SCREWS, SELF-TAPPING

1

8B x

"L

4

6. If required, make any AC electrical connections using the supplied DIN
rail terminal blocks and a flat tip screwdriver.

Installation Guide - DOC. 6130 CAEN Mounting Kit: CAEN-MK • 3

CAEN Mounting Kit Crestron CAEN-MK

Further Inquiries

If after reviewing this Installation Guide for the CAEN-MK, you cannot locate
specific information or have questions, please take advantage of Crestron's award
winning customer service team by calling:

• In the US and Canada, call Crestron’s corporate headquarters at
1-888-CRESTRON [1-888-273-7876].

• In Europe, call Crestron International at [phone].

• In Asia, call Crestron Asia at [phone].

• In Latin America, call Crestron Latin America at [phone].

• In Australia and New Zealand, call Crestron Pacific at

[phone].

Future Updates

As Crestron adds improvements to the CAEN-MK, additional information may be
made available as manual updates. These updates are solely electronic and serve as
intermediary supplements prior to the release of a complete technical documentation
revision.

Check the Crestron website (www.crestron.com
availability and its subjective value. Updates are available from the Download |
Product Manuals section and are identified as an “Addendum” in the Download
column.

) periodically for manual update

4

• CAEN Mounting Kit: CAEN-MK Installation Guide - DOC. 6130

Crestron CAEN-MK CAEN Mounting Kit

Return and Warranty Policies

Merchandise Returns / Repair Service

1. No merchandise may be returned for credit, exchange, or service without prior authorization
from CRESTRON. To obtain warranty service for CRESTRON products, contact the factory
and request an RMA (Return Merchandise Authorization) number. Enclose a note specifying
the nature of the problem, name and phone number of contact person, RMA number, and
return address.

2. Products may be returned for credit, exchange, or service with a CRESTRON Return
Merchandise Authorization (RMA) number. Authorized returns must be shipped freight
prepaid to CRESTRON, Cresskill, N.J., or its authorized subsidiaries, with RMA number
clearly marked on the outside of all cartons. Shipments arriving freight collect or without an
RMA number shall be subject to refusal. CRESTRON reserves the right in its sole and
absolute discretion to charge a 15% restocking fee, plus shipping costs, on any products
returned with an RMA.

3. Return freight charges following repair of items under warranty shall be paid by CRESTRON,
shipping by standard ground carrier. In the event repairs are found to be non-warranty, return
freight costs shall be paid by the purchaser.

CRESTRON Limited Warranty

CRESTRON ELECTRONICS, Inc. warrants its products to be free from manufacturing defects in materials
and workmanship under normal use for a period of three (3) years from the date of purchase from
CRESTRON, with the following exceptions: disk drives and any other moving or rotating mechanical
parts, pan/tilt heads and power supplies are covered for a period of one (1) year; touchscreen display and
overlay components are covered for 90 days; batteries and incandescent lamps are not covered.

This warranty extends to products purchased directly from CRESTRON or an authorized CRESTRON
dealer. Purchasers should inquire of the dealer regarding the nature and extent of the dealer's warranty, if
any.

CRESTRON shall not be liable to honor the terms of this warranty if the product has been used in any
application other than that for which it was intended, or if it has been subjected to misuse, accidental
damage, modification, or improper installation procedures. Furthermore, this warranty does not cover any
product that has had the serial number altered, defaced, or removed.

This warranty shall be the sole and exclusive remedy to the original purchaser. In no event shall
CRESTRON be liable for incidental or consequential damages of any kind (property or economic damages
inclusive) arising from the sale or use of this equipment. CRESTRON is not liable for any claim made by a
third party or made by the purchaser for a third party.

CRESTRON shall, at its option, repair or replace any product found defective, without charge for parts or
labor. Repaired or replaced equipment and parts supplied under this warranty shall be covered only by the
unexpired portion of the warranty.

Except as expressly set forth in this warranty, CRESTRON makes no other warranties, expressed or
implied, nor authorizes any other party to offer any warranty, including any implied warranties of
merchantability or fitness for a particular purpose. Any implied warranties that may be imposed by law are
limited to the terms of this limited warranty. This warranty statement supercedes all previous warranties.

Trademark Information

All brand names, product names, and trademarks are the sole property of their respective owners. Windows is a registered trademark
of Microsoft Corporation. Windows95/98/Me/XP and WindowsNT/2000 are trademarks of Microsoft Corporation.

Installation Guide - DOC. 6130 CAEN Mounting Kit: CAEN-MK • 5

Crestron Electronics, Inc. Installation Guide – DOC. 6130

15 Volvo Drive Rockleigh, NJ 07647 05.03
Tel: 888.CRESTRON
Fax: [phone] Specifications subject to
www.crestron.com change without notice.