Crestron CAEN-CK-7X1, CAEN-CK-7X2 User Manual

CAEN-CK-7x1, 7x2

Functional Summary

The CAEN-CK-7x1 & 7x2 CAEN Cover Extension Kits
are designed to increase the overall depth of the CAEN­7x1 and CAEN-7x2 automation enclosures by 1.5 inches.
Adding depth to these enclosures allows the enclosure to
accommodate excess wiring and third-party devices that
may not normally fit in the standard enclosure.

CAEN-CK Overall Dimensions (Front and Side Views)

HORIZONTAL

PAN (x2)

The following table lists the dimensions for the
CAEN-CK-7x1 and CAEN-CK-7x2.

Dimensions of Enclosure Cover Kits

DIMENSION CAEN-CK-7x1 CAEN-CK-7x2

H 62.00 in 62.00 in

D 1.50 in 1.50 in

W 15.35 in 26.50 in

Installation

The cover extension kit should be attached to a Crestron®
Automation Enclosure in accordance with all national and
local electrical codes. The enclosure cover and screws
must be removed prior to installation. Both must be
retained and used with the supplied screws to complete
the following procedure.

Refer to the following procedure shown in the installation
diagram when installing the CAEN Cover Extension Kit.

Installation Diagram

VERTICAL

BRACKET (x4)

W

H

D

1. As shown in the installation diagram, place a
horizontal pan on the bottom and top of the CAEN
enclosure (edges facing inward). Use a #2 Phillips
tip screwdriver to secure the horizontal pans to the
enclosure using the 8-32 screws.

Crestron Electronics, Inc. Installation Guide – DOC. 6337

15 Volvo Drive Rockleigh, NJ 07647 12.04
Tel: 888.CRESTRON
Fax: [phone] Specifications subject to
www.crestron.com change without notice.

CAEN Cover Extension Kits Crestron CAEN-CK-7x1, 7x2

2. As shown in the installation diagram, place two
vertical brackets on the right side and two vertical
brackets on the left side of the CAEN enclosure
(edges facing outward). Use a #2 Phillips tip
screwdriver and the 8-32 screws to loosely attach the
vertical brackets to the enclosure.

3. Secure the vertical brackets to the secured horizontal
pans with a #2 Phillips tip screwdriver and the 8-32
screws. Tighten the screws holding the vertical
brackets to the CAEN enclosure.

4. After installing the required devices, use the
remaining screws to install the CAEN cover.

Further Inquiries

If you cannot locate specific information or have
questions after reviewing this guide, please take
advantage of Crestron's award winning customer service
team by calling the Crestron corporate headquarters at
1-888-CRESTRON [1-888-273-7876]. For assistance in
your local time zone, refer to the Crestron website
(

www.crestron.com

offices.

) for a listing of Crestron worldwide

Return and Warranty Policies

Merchandise Returns / Repair Service

1. No merchandise may be returned for credit, exchange, or
service without prior authorization from CRESTRON. To
obtain warranty service for CRESTRON products, contact
the factory and request an RMA (Return Merchandise
Authorization) number. Enclose a note specifying the nature
of the problem, name and phone number of contact person,
RMA number, and return address.

2. Products may be returned for credit, exchange, or service
with a CRESTRON Return Merchandise Authorization
(RMA) number. Authorized returns must be shipped freight
prepaid to CRESTRON, 6 Volvo Drive, Rockleigh, N.J., or
its authorized subsidiaries, with RMA number clearly marked
on the outside of all cartons. Shipments arriving freight
collect or without an RMA number shall be subject to refusal.
CRESTRON reserves the right in its sole and absolute
discretion to charge a 15% restocking fee, plus shipping
costs, on any products returned with an RMA.

3. Return freight charges following repair of items under
warranty shall be paid by CRESTRON, shipping by standard
ground carrier. In the event repairs are found to be non­warranty, return freight costs shall be paid by the purchaser.

CRESTRON Limited Warranty

CRESTRON ELECTRONICS, Inc. warrants its products to be free from
manufacturing defects in materials and workmanship under normal use
for a period of three (3) years from the date of purchase from
CRESTRON, with the following exceptions: disk drives and any other
moving or rotating mechanical parts, pan/tilt heads and power supplies
are covered for a period of one (1) year; touchscreen display and overlay
components are covered for 90 days; batteries and incandescent lamps
are not covered.

This warranty extends to products purchased directly from CRESTRON
or an authorized CRESTRON dealer. Purchasers should inquire of the
dealer regarding the nature and extent of the dealer's warranty, if any.

CRESTRON shall not be liable to honor the terms of this warranty if the
product has been used in any application other than that for which it was
intended, or if it has been subjected to misuse, accidental damage,
modification, or improper installation procedures. Furthermore, this
warranty does not cover any product that has had the serial number
altered, defaced, or removed.

This warranty shall be the sole and exclusive remedy to the original
purchaser. In no event shall CRESTRON be liable for incidental or
consequential damages of any kind (property or economic damages
inclusive) arising from the sale or use of this equipment. CRESTRON is
not liable for any claim made by a third party or made by the purchaser
for a third party.

CRESTRON shall, at its option, repair or replace any product found
defective, without charge for parts or labor. Repaired or replaced
equipment and parts supplied under this warranty shall be covered only
by the unexpired portion of the warranty.

Except as expressly set forth in this warranty, CRESTRON makes no
other warranties, expressed or implied, nor authorizes any other party to
offer any warranty, including any implied warranties of merchantability
or fitness for a particular purpose. Any implied warranties that may be
imposed by law are limited to the terms of this limited warranty. This
warranty statement supercedes all previous warranties.

Trademark Information

All brand names, product names, and trademarks are the sole property of their respective
owners. Windows is a registered trademark of Microsoft Corporation. Windows95/98/Me/XP
and WindowsNT/2000 are trademarks of Microsoft Corporation.

2 • CAEN Cover Extension Kits: CAEN-CK-7x1, 7x2 Installation Guide – DOC. 6337