Cres Cor H137S96BCDJ1 Service Manual

5925 Heisley Road • Mentor, OH 44060-1833

OPERATING and MAINTENANCE INSTRUCTIONS

Model: H137S96BC-J Series Banquet Cabinet

ELECTRICAL SPECIFICATIONS:

Model No. Volts Watts Amps Hertz Phase NEMA

H137S96BCJ1
H137S96BCDJ1

100 1400 14 50/60 1 5-15

Insulated

Banquet Cabinet

Rev. 2 (3/07) Page 1 of 4

FL-2258-J

H137S96BCJ2
H137S96BCDJ2

HOW TO INSTALL UNIT:

Place cabinet on level fl oor.

1.
Plug cord end into proper wall outlet.

2.

208 2000 9.6 50/60 1 6-15

HOW TO START UNIT:

Turn the POWER switch on. The yellow light will

1.
turn on.
Turn thermostat to #7.

2.
Preheat cabinet for 60 minutes.

3.
Put food into cabinet.

4.
Turn thermostat to #8 and close door.

5.
No. 8 setting = approx. 85°C (185°F)

No. 6 setting = approx. 71°C (160°F)
No. 4 setting = approx. 54°C (130°F)

Proper food holding temperature is 60°C (140°F) or
higher.

Call Toll-free: 877-CRES COR (273-7267) • Fax: [phone] • www.crescor.com

TO TURN OFF UNIT:

Push the POWER switch off.
The yellow light will go out.

Insulated

Banquet Cabinet

Rev. 2 (3/07) Page 2 of 4

FL-2258-J

OPERATING and MAINTENANCE INSTRUCTIONS

Model: H137S96BC-J Series Banquet Cabinet

HOW TO CLEAN THE CABINET:

BEFORE cleaning
the cabinet:

Allow cabinet to cool.

1.
Remove Hot unit from cabinet.

2.
Do NOT use abrasives or harsh

3.
chemicals.

5925 Heisley Road • Mentor, OH 44060-1833

Cleaning Notes:

Wipe up spills as soon as possible.

1.
Clean cabinet regularly to avoid heavy dirt build-up.

2.
Make a test spot with cleaner.

3.
Follow manufacturer’s directions on cleaner.

4.
Do not mix cleaners.

5.
Avoid drips and splashes.

6.

HOW TO CLEAN THE UNIT:

SOIL CLEANER METHOD

1. Use soft, damp cloth.

2. Rinse with hot water.

3. Wipe dry.

1. Rinse after steam cleaning.

2. Wipe dry.
Follow oven cleaner

manufacturer’s directions.
Apply with soft, clean cloth.

1. Wipe with damp cloth.

2. Rinse and dry.

STAINLESS

STEEL

BANQUET

CABINET

Mild detergent* and hot water, or mild

DIRT

FINGERPRINTS,
GREASE OIL

WATER SPOTS Mild abrasive cleaner.

* Mild detergents include soaps and non-abrasive cleaners

abrasive cleaner.

Steam (no strong alkaline additive)

Chemical oven cleaner for aluminum.
Mild abrasive cleaner;

oily or waxy cleaner.

TROUBLE-SHOOTING CHART:

FAILURE POSSIBLE CAUSE

1. Yellow light at switch does NOT light

2. Unit does not heat.

3. Unit gets too hot or won’t shut off. 3a. Defective electrical parts. UNPLUG UNIT

4. Blower does not work or make noise. 4a. Defective blower.

1a. Circuit breaker/fuse to wall outlet is blown.
1b. Cord is unplugged from wall outlet.
1c. Switch is “OFF”.

2a. Thermostat set too low or is “OFF”.
2b. Switch is “OFF”.

FROM WALL OUTLET.

If cause is none of the above, refer to our list of Authorized Service Centers, FL-1400.

Call Toll-free: 877-CRES COR (273-7267) • Fax: [phone] • www.crescor.com