Creek Audio A50i, A50i R Instruction

CREEK A50i and A50i R SPECIFICATION

POWER OUTPUT (both channels) 50 W into 8

ΩΩ

POWER OUTPUT (one channel) 60 W into 8

ΩΩ

POWER OUTPUT (one channel) 80 W into 4

ΩΩ

Not recommended for use into more than one pair of 4 Ωloudspeakers.

TOTAL HARMONIC DISTORTION < 0·05% 20 Hz to 20 kHz

FREQUENCY RESPONSE 3 Hz to 25 kHz - 1 dB

SLEW RATE > 40 V per µµS

INPUT SENSITIVITY (passive) 450 mV

SIGNAL TO NOISE RATIO (‘A’ weighted) > 100 dB

SEPARATION (line input) > 60 dB at 1 kHz

MM SENSITIVITY AND IMPEDANCE (when fitted) 3.5 mV 47k

ΩΩ

MC SENSITIVITY AND IMPEDANCE (when fitted) 0.75 mV 1k

ΩΩ

POWER CONSUMPTION (at idle) < 45 W

POWER CONSUMPTION (full power 10% THD) 260 W

WEIGHT 6 kg, 13.2 lbs

SIZE 430 x 65 x 250 mm

17” x 2·75” x 10''

MAINS VOLTAGE @ 60Hz 100V Japan, 115V North America

@ 50Hz 230/240V Europe, Asia and UK

MAINS VOLTAGE AND FREQUENCY IS INTERNALLY SET FOR THE COUNTRY OF USE

Creek Audio Ltd reserves the right to change or modify the specification of its products without prior warning.

Creek Audio Ltd

12 Avebury Court, Mark Road, Hemel Hempstead, HP2 7TA England

Tel: [phone] Fax: [phone]
E-mail: [e-mail] Internet: www.creekaudio.com

Designed and made in the UK.

Creek A50i
& A50i

R

Operating Instructions

Thank you for purchasing the A50i amplifier.

You are now in possession of a State of the Art Integrated Amplifier. The functions and
operation of the A50i are extremely simple. However, the following notes are provided
to explain all aspects of its design and use. These instructions apply to both the
standard and remote versions of the A50i.

MAINS CONNECTION

When unpacking the amplifier please keep the packing material in a safe place for
possible future use. In the pack there is a separate mains cable with a moulded plug
suitable for connecting to the mains supply in the country of use. The IEC socket end
of the cable should be firmly inserted into the connector on the rear panel marked
"Mains Input".

The high quality performance of the amplifier will be impaired if the electrical supply to
it is in poor condition. If in doubt, consult a qualified electrician or your supplying
dealer. The "Mains Input" connection is also fitted with a fuse, specifically suited to the
supply voltage of the country of use. The correct value is clearly marked on the rear
panel next to the Mains Input.

Should it be necessary to replace the fuse, ensure that you use the same type as
specified on the rear panel:

i.e: 5 x 20mm cartridge type T 2A surge resisting for 220-240V 50Hz AC, T 4A
surge resisting for 110-120V 60Hz AC.