Creda IDI60 User Manual

Instructions for Installation and Use

Dishwasher

Model IDI60

To the Installer:

Before installation please make a note of the product details specified on the back cover

of this book.

The information can be found on the rating plate.

To the User:

You must read the instructions prior to installing and using the appliance

and then retain them for future reference.

ISHWASHER

D

Contents

Electrical Connection
For Your Safety
Installation
Getting to know your Dishwasher
The Controls
How to use your Dishwasher
Programme Chart
Before Using your Dishwasher
Loading your Dishwasher
Care and Cleaning
Troubleshooting
Information for Test Labs
Key Contacts

3
4
5
6
6
7
8

9-10

11

12
13
14

Back Cover

Retention of this Instruction Book

This Instruction Book must be kept handy for reference as it contains important details on the safe and proper use of the
appliance.

If you sell or pass the appliance to someone else, or move house and leave it behind, make sure this Book is also
provided so the new owner can become familiar with the appliance and safety warnings.

If the Book is lost or damaged a copy may be obtained from:
GDA LTD., Morley Way, Peterborough, PE2 9JB

2

Electrical Connection

WARNING: This appliance must be earthed.

ISHWASHER

D

Fuses

Your appliance comes fitted with a plug and a 13A fuse. If you need to
replace the fuse, only those rated at 13A and ASTA approved to
BS1362 should be used. If you lose the fuse cover, a replacement
may be obtained from your local authorised Service Centre or
Electrical company. Correct replacement is identified by colour coding
or the marking on base of plug.

WARNING: DO NOT use the plug unless the fuse cover is fitted.

Safety Information

At the time of delivery...
All functions of your dishwasher have been thoroughly tested at the
factory. A small number of water marks may have been left as a
result, they will disappear when the appliance is used for the first time.

WARNING: The dishwasher must not be connected to the electricity
supply while installation is being carried out.

- This appliance should only be connected to a 230/240V AC

Changing the Plug

Cut off and dispose of the supplied plug if it does not fit your socket.

WARNING: T o avoid a shock hazard DO NOT insert the discarded plug
into a socket anywhere else.

IMPORTANT: WIRES IN THE MAINS LEAD ARE COLOURED IN
ACCORDANCE WITH THE FOLLOWING CODE:
Green/Yellow - Earth
Blue - Neutral
Brown - Live

If you change the plug, the colour of the wires in the mains lead may
not correspond with the terminal markings in the plug, which if not
coloured, could be:
EARTH ‘E’ or
NEUTRAL ‘N’
LIVE ‘L’

- Use the dishwasher solely in a domestic environment.

- DO NOT stand or place heavy objects on the door when it is

If your family includes children...

- DO NOT allow children to play with the appliance or tamper

- Keep detergents and rinse aids away from children. Keep

source, via a properly installed earthed socket.

open, this could damage the door or cause the appliance to tip
forward.

with its controls.
children away from the open door of a dishwasher, there could

still be some detergent left inside.

Changing the Mains Lead

A lead can be ordered from Creda Service
UK: 08709 066 066 or
Republic of Ireland: 1850 302 220
If you have damaged the existing lead or require a longer one a
charge will be made. It is strongly advised that this work is carried out
by a qualified electrician.

If the domestic wiring includes a residual current-operated circuit
breaker, ensure that it conforms to the latest regulations.

CAUTION:

The dishwasher meets the requirements set out by the regulations in
force concerning safety and electrical equipment.
Any technical checks should be conducted exclusively by a trained
and authorised technician: Repairs carried out by unaithorised
persons will invalidate the guarantee, as well as posing a potential
hazard to the user.

The manufacturer declines all responsibility for damage to persons or
property resulting from failure to observe the above precautions, from
tampering with even a single component or from the use of non­original spare parts.

3

ISHWASHER

D

For your Safety

This manual forms an integral part of the appliance. It must always be kept handy for reference. Read through all the instructions contained in this manual
before using the dishwasher.

Installation must be performed by a qualified technician, in compliance
with the regulations in force, including the prevention and elimination of
radio frequency interference.

The dishwasher is designed for washing and drying dishes, any
other use shall be considered improper. The manufacturer declines
all responsibility for uses other than those described above.

1. Seperate the various
packaging materials and
dispose of safely - DO NOT
leave discarded packaging
material around the home.

2. After removing the packaging,
check to make sure your
appliance is intact. If in doubt,
contact a qualified
professional.

3. DO NOT use extension leads
and multiple plugs. If the
electricity supply wire is not
long enough, then have it
replaced with one of the correct
length and remember that it
should be free of bends or
dangerous kinks.

4. In the event of any damage to
the power cord have it
replaced by a qualified
technician.

5. The mains plug must be easily
accessible after installation.

6. If the appliance is not operating
properly or if maintenance
operations are necessary,
disconnect the dishwasher
from the mains power supply
(unplug it!).

7. DO NOT install outdoors, not
even if the area is covered by
a roof: it is extremely
dangerous to leave it exposed
to rain and thunderstorms.

8 . If installed on a carpeted or

covered floor, ensure that the
openings on the underside are
not obstructed.

9. Do not touch the heating
element during or straight after
a wash cycle.

10. If the appliance malfunctions,
turn off the water inlet tap and
disconnect the plug from the
wall socket. Then read the
section entitled
"Troubleshooting". If you
cannot resolve the problem,
then call Creda Service (see
KEY CONTACTS, back
page).

The rating plate, featuring the
technical data, serial number
and markings, is visibly
positioned on the inner edge of
the door.
DO NOT remove the rating plate.

The dishwasher is intended for use by adults. DO NOT allow children
to come near or play with the controls.

Keep children away from detergents and clear of the dishwasher door
when open.
Keep all packaging material away from children.

1 . DO NOT use solvents, such as alcohol or turpentine which may

cause an explosion.

2. DO NOT load dishes to wash that are soiled with ash, wax or paints.

3. DO NOT lean, sit or stand on any part of the dishwasher - this could
cause injury and/or damage the appliance.

4. DO NOT drink any water residues from inside the dishwasher.

4

Installation

ISHWASHER

D

Choose where you want to install
your dishwasher, you can place it
so that its sides or back panel are
side by side with furniture or up
against the wall. The dishwasher is
provided with water supply and drain
hoses, which can be directed
towards the left or right to facilitate
appropriate installation.

Levelling.

Once the appliance is positioned,
adjust the feet by screwing them in
or out depending on how high you
want it and to level it so that it is
horizontal. Make sure that it is not
inclined more than 2 degrees. If the
appliance is level, it will help ensure
its correct operation.

Height Adjustment

Insert the appliance into the cutout
and then adjust the height using the
screws located on the front bottom
part of the machine. Use a
screwdriver to turn the screws in
the clockwise or anti-clockwise
direction to increase or decrease
the height respectively.

Cold water connection.
Connect the cold water supply
hose, inserting the small filter
supplied with the dishwasher and
making sure that it is fastened tightly
in place (see figure 2). If the water
hoses are new or have been out of
use for an extended period of time,
let the water run to make sure it is
clear and free of impurities before
making the connection. If this
precaution is not taken, the water
inlet could get blocked, causing
damage to your dishwasher.

A

Fig.2

Drain hose connection.

WARNING: Connect your
dishwasher drain hose to pipes
which connect to the foul drain
system and not to surface water
drains.
IMPORTANT: For the correct
operation of your dishwasher, it is
essential to comply with the following
information:-

Standpipe:

Ensure that the hose is not pushed
too far down the standpipe.
If the end of your drain hose is fitted
with ‘retaining flaps’, ensure they are
inserted fully into the standpipe. This
will prevent the pipe from jumping
out during installation and use.

DO NOT position the standpipe
near an electrical outlet.
ENSURE that the drain hose is not
kinked and it is routed as shown in
the diagram.

The standpipe should have a bore
of at least 38mm (11/2”). It should
be installed as shown, have a trap
fitted and must discharge into the
same drain system as your
household sink.
It MUST NOT be connected to a
surface water drain.

Sink Waste System:

For under sink drainage:
Before connecting the drain hose,
remove any internal restrictions ­This will prevent a build up of debris
which could cause a blockage.
Remove any restrictions from the
waste spigot and ensure that the
sealing bung is removed. The hose
should be routed, such that it is
raised to a minimum height of
800mm (31/2”).

NOTE: Ensure the sink outlet
pipe has a minimum diamtere of
32mm.

1. Untie the end of the GREY
drainage hose from the rear of
the appliance.

2. Reposition the ‘Hooked End
Support’ as required along the
GREY drainage hose.

3. If fitting an under sink waste
disposal unit, cut out the
membrane, bung or blanking
plug.

4. Attach the GREY drainage
hose to the under sink waste
disposal unit securely, using the
clip and rubber tube supplied.

Ensure the drain hose is
securely attached, to prevent
it coming away while the
machine is in use and causing
a flood.

5