Crate & Barrel Puzzle Bookcase Connectors Assembly Instruction

Customer Service 800-967-6696 | http://www.crateandbarrel.com

PUZZLE SET OF 2 BOOKCASE CONNECTORS

Thank you for purchasing the Puzzle Set of 2 Bookcase
Connectors. This page lists all the contents included in

the box. Please take time to identify the hardware as well
as the individual components of this product. As you
unpack and prepare for assembly, place the contents on a
carpeted or padded area to protect them from damage.

NOTE: These units are designed to be used in conjunction
with the Puzzle Bookcase. Do not use these as stand-alone
storage units.

COMPONENTS

4 - short panels

(2 left, 2 right)

4 - long panels

(2 top, 2 bottom)

2 - back panels

Made in China 2004

HARDWARE

16 - cams

24 - wood dowels

Missing hardware? Please call 800.606.6387 for
replacements.

16 - cam screws

8 - felt pads

TOOLS REQUIRED

Phillips head screwdriver

IMPORTANT NOTE:

You will be building 2 identical units. The following
instructions are for building a single unit, so these
instructions will need to be repeated for assembly
of the 2nd unit.

1 Place 2 short panels on the floor with the holes
facing up. Insert 4 cam screws per panel into the inner
holes and secure with a phillips head screwdriver.

Page 1 of 3

Customer Service 800-967-6696 | http://www.crateandbarrel.com

PUZZLE SET OF 2 BOOKCASE CONNECTORS

x 2

2 A. Insert 4 cams into each long panel, making sure the
arrow on the cam points out towards the edge with the holes.
B. Insert 4 wood dowels into the outer holes of each
long panel.

4 Place other short panel into postion, aligning dowels,
cam screws and back panel with corresponding holes and
slot.

Made in China 2004

Arrow points out,

towards edge

with holes

A

B

A

3 A. Align dowels of the 2 long panels with holes in 1
short panel and fit into position. Make sure the slot of each
panel is at the rear of the assembly.
B. Slide back panel into the slot at the rear of the assembly.

B

x 8

Cam in
unlocked
position

5 Secure the assembly by turning each cam 90 degrees
clockwise with a screwdriver. Turn the cam until the arrow
points away from the edge of the panel.

Cam in
locked
position

Page 2 of 3