Crate & Barrel Pull Out Table Assembly Instruction
ROLL OUT DESK
HARDWARE
Thank you for purchasing the Roll Out Desk. This page
lists all the contents included in the box. Please take
time to identify the hardware as well as the individual
components of this product. As you unpack and
prepare for assembly, place the contents on a carpeted
or padded area to protect them from damage.
Note: 2 people are required to safely assemble this product.
COMPONENTS
13 - flat
washers
13 - spring
washers
19 - wood
dowels
4 - cam
screws
Missing hardware? Please call
800.606.6387 for replacements.
4 - cams
4 - screws
TOOLS REQUIRED
allen wrench (included)
phillips head screwdriver
(We recommend the use of hand tools instead of power tools)
ASSEMBLY
NOTE: Make sure arrows
on each cam point toward
nearest edge with holes
13 - bolts
front
crossbar
1 - keyboard tray
1 - desktop
back
crossbar
1 - back
crossbar
1 - back
panel
2 - side frames
(1 left, 1 right)
1 - front
crossbar
desktop
1 A) Insert 2 cams into back crossbar and front cross-
1 - keyboard tray
leg frame
1 - keyboard
crossbar
bar as shown. Make sure arrows on each cam point
toward nearest edge with holes.
B) Insert 4 wood dowels into desktop as shown.
Made in China - r03 Page 1 of 3
Customer Service 800.967.6696 | Latest instructions avaliable at www.crateandbarrel.com
ROLL OUT DESK
NOTE: Do not over
tighten the cam screws
front
crossbar
back
panel
B
B
back
crossbar
left and right
side frames
2 Insert 2 cam screws and 5 wood dowels into left and
right side frames as shown. Secure, but do not over tighten,
cam screws using a phillips head screwdriver.
right side
frame
A
B
A
left side
frame
A
NOTE: Do not over
tighten the bolts
3 A) Fit wood dowels of left side frame into corresponding holes of front and back crossbar. Using a
phillips head screwdriver, turn cams clockwise until
each cam securely engages each cam screw.
B) Fit wood dowels of left side frame into corresponding
holes of back panel. Secure back panel with 1 bolt, 1
spring washer and 1 flat washer, using an allen
wrench. Do not over tighten the bolts.
B
front
crossbar
back
panel
4 A) Fit wood dowels of right side frame into corresponding holes of front/back crossbar and back panel. Secure all
cams.
B) Secure back panel to right side panel with 1 bolt, 1
spring washer and 1 flat washer, using an allen wrench.
Made in China - r03
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
A
back
crossbar
desktop
5 Place desktop onto a clean, padded surface. With
the assistance of another adult, fit dowels of desktop
into corresponding holes of assembly. Secure desktop
with 7 bolts, 7 spring washers and 7 flat washers,
using an allen wrench. Place assembled unit upright.
Page 2 of 3
Loading...