Crate & Barrel Porto Four-Drawer Chest Assembly Instruction
PORTO FOUR DRAWER CHEST
HARDWARE
Thank you for purchasing the Porto Four Drawer
Chest. This page lists the contents included in the
box. Please take time to identify the hardware as well
as the individual components of this product. As you
unpack and prepare for assembly, place the contents
on a carpeted or padded area to protect them from
damage.
COMPONENTS
1 - medium
screw
2 - wall
brackets
Missing hardware?
Please call 800.606.6387 for replacements.
1 - large
screw
1 - wall strap
1 - metal
anchor
TOOLS REQUIRED
phillips head screwdriver
(We recommend the use of hand tools instead of power tools)
ASSEMBLY
1 - chest
assembly
1
With the assistance of another adult, position chest
4 - feet
Made in China - r02 Page 1 of 2
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
assembly on its side as shown on a clean, padded
surface. Insert 4 feet into dresser assembly and turn feet
clockwise to secure. Carefully position unit upright.
Assembly is now complete.
PORTO FOUR DRAWER CHEST
NOTE: If you are unsure
about your wall type or
what mounting method you
should use, consult a
qualified professional or
your local hardware store.
F
wall strap
D
large screw
A
wall bracket &
small screw
C
metal
anchor
WALL MOUNTING INSTRUCTIONS
For added safety and stability, it is recommended that the
wall mounting hardware be installed. For safe mounting, it
is essential to use wall anchors appropriate to your wall
type (i.e. plaster, drywall, concrete, etc.). Mount to wood
studs whenever possible.
A) Attach 1 wall bracket to assembled unit as shown,
using 1 small screw.
B) Determine the final location of dresser unit. Mark
position on the wall, approximately 2" below the bracket
mounted to the back of the unit.
C) Drill a pilot hole in the wall stud. If the wall stud is not
available, drill a hole in the wall that is slightly smaller in
diameter than the anchor. Insert metal anchor into hole
and secure using a phillips screwdriver.
D) Attach the wall bracket to the wall by inserting 1 large
screw through the wall bracket and into the metal anchor
in the wall.
E) Place the unit so the wall bracket on the back edge is
aligned with the wall bracket on wall.
F) Lace one end of the wall strap through both brackets,
and into the other end of the strap.
G) Pull the strap tightly until secure.
CLEANING & CARE
Clean surfaces with a dry or damp soft cloth. Do not
use abrasive cleaners. Do not use furniture wax or
polish as the unit is finished with a protective clear
lacquer. It is recommended to use coasters to protect
surface from heat and water.
Wall mounting assembly is now complete.
Made in China - r02 Page 2 of 2
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
Loading...