Crate & Barrel Plateau Media Stand Assembly Instruction

Customer Service 800-967-6696 | http://www.crateandbarrel.com

PLATEAU MEDIA STAND

Thank you for purchasing the Plateau Media Stand.
This page lists all the contents included in the box.
Please take time to identify the hardware as well as
the individual components of this product. As you
unpack and prepare for assembly, place the
contents on a carpeted or padded area to protect
them from damage.

COMPONENTS

1 - front frame

2 - rear frames

1 - glass top

2 - glass shelves

Made in China

HARDWARE

4 - allen
head screws

8 - rubber bumpons 4 - sponge bumpons

Missing hardware? Please call 800.606.6387 for replacements.

2 - short
machine screws

2 - shelf pins

4 - tube caps

TOOLS REQUIRED

Allen Wrench (included)

Phillips head screwdriver

Hammer

A

B

C

1 A. Lay front frame face down with the tube fittings
facing up. Insert 2 shelf pins into threaded holes of front
frame and tighten with the allen wrench.
B. Slide 1 rear frame over tube fitting and fit shelf pins and
small brackets into the smaller tubes of rear frame.
C. Secure frames with 2 allen head screws using allen
wrench.

Page 1 of 2

Customer Service 800-967-6696 | http://www.crateandbarrel.com

PLATEAU MEDIA STAND

2 A. Attach remaining rear frame to assembly with 2 allen
screws using method outlined in Step 1.

B. Secure bottom shelf with 2 short machine screws.
Fully tighten with a phillips head screwdriver.

4 With the assistance of another adult, lift assembled
frame into an upright position. Remove adhesive backer
and attach 4 sponge bumpons on the top shelf and 4
rubber bumpons on each lower shelf support.

Made in China

3 Insert 1 plastic tube cap onto bottom of each leg.
Secure into place by gently tapping with a hammer.

5 Install glass top and shelves as shown, making sure
each shelf is solidly supported by the bumpons.
Assembly is now complete.

CARE & CLEANING

Clean as needed with a damp cloth.

Page 2 of 2