PILSEN BOOKCASE
ASSEMBLY HARDWARE
Thank you for purchasing the Pilsen Bookcase. This
page lists all the contents included in the box. Please
take time to identify the hardware as well as the individual
components of this product. As you unpack and prepare
for assembly, place the contents on a carpeted or
padded area to protect them from damage.
Note: 2 people are required to safely assemble this product.
COMPONENTS
40 - bolts
20 - bumpers
MOUNTING HARDWARE
1 - large
screw
Missing hardware? Please call 800.606.6387 for replacements.
1 - small
bolt
2 - wall
brackets
1 - wall
strap
1 - plastic
anchor
TOOLS REQUIRED
allen wrench (included)
phillips head screwdriver
(We recommend the use of hand tools instead of power tools)
1 - top crossbar
(anti-tip pilot hole)
9 - crossbars
2 - side frames
(1 left, 1 right)
5 - glass shelves
Made in China - r03 Page 1 of 3
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
PILSEN BOOKCASE
top crossbar
right side frame
crossbar
NOTE: Do not over tigthen the bolts
1 With assistance of another adult, fit 1 top
crossbar and 9 crossbars over corresponding
brackets of left side frame as shown. Loosely
attach each crossbar with 2 bolts as shown,
using an allen wrench.
Repeat steps for right side frame.
NOTE: Make sure all pilot
holes are assembled towards
the bottom as shown
glass shelf
B
A
left side frame
At this point, fully tighten all bolts but do not
over tighten. Position unit upright.
A
CLEANING & CARE
Clean surfaces with a dry or damp soft cloth. Do
not use abrasive cleaners.
2 A) Adhere 4 bumpers per shelf as shown. Press
firmly to secure.
B) Carefully place 5 glass shelves onto corresponding
bumpers of assembly. Make sure each shelf is securely
supported by bumpers.
Assembly is now complete.
Made in China - r03 Page 2 of 3
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
PILSEN BOOKCASE
DETAIL VIEW
FROM BELOW
small bolt
plastic anchor
D
large screw
F
wall strap
WALL
A
C
wall bracket
wall bracket
OPTIONAL WALL MOUNTING INSTRUCTIONS:
For added safety and stability, it is recommended that the wall mounting hardware be
installed. For safe mounting, it is essential to use wall anchors appropriate to your
wall type (i.e. plaster, drywall, concrete, etc.). Mount to wood studs whenever
possible.
A) Attach wall bracket to top of unit using 1 small bolt as shown.
B) Determine the final location of unit. Mark position on the wall, approximately 2"
below the wall bracket mounted to the back of the unit.
C) Drill a pilot hole in the wall stud. If the wall stud is not available, drill a hole in the
wall that is slightly smaller in diameter than the anchor. Gently tap the plastic anchor
until the flange of the anchor is flush with the wall.
D) Attach wall bracket to the wall by inserting 1 large screw through bracket and
into the plastic anchor in the wall.
E) Place the unit so the wall brackets on the back edge are aligned with the wall
brackets on the wall.
F) Lace one end of the wall strap through both brackets, and into the other end of
the strap.
G) Pull the strap tightly until secure.
NOTE:
If you are unsure about your
wall type or what mounting
method you should use,
consult a qualified
professional or your local
hardware store.
Wall mounting assembly is now complete.
Made in China - r03 Page 3 of 3
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
Loading...