Crate & Barrel Paterson Desk Assembly Instruction
PATERSON DESK
HARDWARE
Thank you for purchasing the Paterson Desk. This
page lists all the contents included in the box. Please
take time to identify the hardware as well as the
individual components of this product. As you unpack
and prepare for assembly, place the contents on a
carpeted or padded area to protect them from damage.
Note: 2 people are required to safely assemble this product.
COMPONENTS
2 - wood
dowels
12 - spring
washers
4 - cam
screws
12 - flat
washers
8 - small
bolts
4 - barrel nuts
4 - large
bolts
pre-installed
set screws
Missing hardware?
Please call 800.606.6387 for replacements.
TOOLS REQUIRED
phillips head screwdriver
allen wrench (included)
(We recommend the use of hand tools instead of power tools)
A
B
right drawer
glide
drawer
assembly
1 - desktop
assembly
(drawer assembly
pre-installed)
left drawer
glide
desktop
assembly
1 Fully extend drawer assembly from desktop assembly.
Locate plastic tabs on left and right drawer glides. With even
2 - side frames
1 - crossbar
(1 left, 1 right)
Made in China - r06 Page 1 of 4
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
pressure, simultaneously lift the left tab (A) and press the right
tab (B) to release drawer assembly from assembled unit. Set
drawer aside.
PATERSON DESK
NOTE: Do not
over tighten the
cam screws
left and right
side frames
A
2 A) Insert 2 cam screws into left and right side
frames as shown. Secure, but do not over tighten,
cam screws with a phillips head screwdriver.
B) Insert 2 wood dowels into crossbar as shown.
crossbar
B
crossbar
B
D
C
set screw
barrel nut
A
D
Align hole of barrel nut
with hole on end of
crossbar
B
C
right side
frame
3 A) Using a screwdriver, remove set screws from
barrel nuts.
B) Insert 1 barrel nut into the crossbar as shown.
Make sure hole of barrel nut aligns with hole on end of
crossbar.
C) Fit dowel of crossbar and cam screw of right side
frame into corresponding holes as shown.
D) Secure crossbar to right side frame by inserting a
set screw into barrel nut. Tighten with a phillips
head screwdriver, making sure set screw securely
engages the cam screw of the right side frame.
Made in China - r06 Page 2 of 4
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
Loading...