Craftsman Sun Shade User Manual

Download

Owner's Manual

SUN SHADE

Model No. 486.24226

CAUTION:

Before using this product, read this manual and follow all Safety Rules and Operating Instructions.

IMPORTANT: For Missing Parts or

Assembly Questions Call 866-576-8388

Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.

www.sears.com/craftsman

• Safety

• Assembly

• Operation

• Maintenance

• Parts

FORM NO. 49290 (REV. 10/05)

TABLE OF CONTENTS

SAFETY RULES ..........................................................2

FULL-SIZE HARDWARE CHART ................................ 3

CARTON CONTENTS .................................................3

ASSEMBLY .................................................................. 4

OPERATION ................................................................7

MAINTENANCE/STORAGE ........................................ 7

REPAIR PARTS ILLUSTRATION ................................ 8

REPAIR PARTS LIST...................................................8

PARTS ORDERING/SERVICE .....................Back Page

SAFETY

Any power equipment can cause injury if operated improperly or if the user does not understand how to operate the equipment. Exercise caution at all times, when using power equipment.

• This sun shade does not provide protection against exhaust fumes, collision, rollover or other accidents.

• Read the sun shade and vehicle owner's manuals and know how to operate your vehicle and sun shade before using the sun shade attachment.

• Be sure there is adequate ventilation when using the

tractor and sun shade in conned areas.

• The sun shade will restrict your eld of vision in some

directions. Use extra caution when operating your tractor with the sun shade attached.

• Watch for low tree limbs or other overhead obstructions that may not previously have interfered with the operation of the tractor. The extra height of the sun shade may cause these objects to become obstacles.

• Check the area of operation thoroughly before using the tractor.

Look for this symbol to point out important safety precautions. It means Attention!! Become

alert!! Your safety is involved.

WARRANTY

ONE YEAR FULL WARRANTY

When operated and maintained according to the instructions supplied with it, if this Sun Shade fails due to a defect in material or workmanship within one year from the date of purchase, call 1-800-4-MY-HOME® to arrange for free repair (or replacement if repair proves impossible).

If this product is used for commercial or rental purposes, this warranty applies for only 90 days from the date of purchase.

This warranty gives you specic legal rights, and you may also have other rights which vary from state to state.

Sears, Roebuck and Co., D817WA, Hoffman Estates, IL 60179

The model number and serial numbers will be found on a decal attached to the base assembly.

You should record both the serial number and the date of purchase and keep in a safe place for future reference.

MODEL NUMBER: 486.24226

SERIAL NUMBER:

DATE OF PURCHASE:

HARDWARE PACKAGE CONTENTS

SHOWN FULL SIZE

REF. QTY. DESCRIPTION

A 5 Bolt, 1/4" x 1-1/4"

B 2 Bolt, 1/4" x 1-1/2" C 2 Bolt, 5/16" x 1-1/4" D 7 Nut, 1/4" Nylock E 2 Spacer

NOT SHOWN FULL SIZE

REF. QTY. DESCRIPTION

F 2 Strap, Tarp G 2 S-Hook H 2 Hook, Spring I 2 Foam Sleeve J 2 Rubber Cap

CARTON CONTENTS

REF. QTY. DESCRIPTION

A 1 Shade, Top

B 2 Tube, Top C 1 Rod, Support (Long) D 1 Rod, Support (Short) E 2 Tube, Upright

REF. QTY. DESCRIPTION

F 1 Tube, Outer Cross G 1 Tube, Inner Cross H 1 Tube, Base (Right) I 1 Tube, Base (Left)

ASSEMBLY

TOOLS REQUIRED FOR ASSEMBLY

(2) 7/16" Wrenches or Socket Wrench (2) 1/2" Wrenches or Socket Wrench

REMOVAL OF PARTS FROM CARTON

Remove all parts and hardware package from the carton. Identify all parts and hardware by referring to the Carton Contents on previous page.

ASSEMBLING SUN SHADE

CAUTION: Make sure tractor seat raises and

lowers freely after attaching Sun Shade. The tractor’s operator presence safety switch will not operate if seat is stuck down.

NOTE: Your tractor fender style may differ from the one

shown in the drawings. The following instructions apply to all fender styles.

• Raise tractor seat to access seat mounting hardware.

• Slide foam sleeve onto left base tube. See gure 2.

HINT: Apply a small amount of soapy water to front edge of sleeve hole to aid in sliding sleeve onto tube.

• Attach left base tube to left seat bracket. Use one

5/16" x 1-1/4" (C) bolt from hardware package and the previously removed original nut. Make sure seat raises and lowers freely. Slightly loosen nuts if seat is too

tight. See gure 2.

• Repeat rst ve steps to install right base tube.

ORIGINAL NUT

5/16" X 1-1/4" HEX BOLT (C)

• Remove original bolt and nut from left side of seat mount bracket.

• Insert supplied spacer (E) into the seat bracket. See

gure 1.

TRACTOR SEAT BRACKET

SPACER (E)

FIGURE 1

FOAM SLEEVE

LEFT BASE TUBE

FIGURE 2

• Attach outer cross tube to inner cross tube using one 1/4" x 1-1/4" (A) bolt and one 1/4" nylock nut (D).

Select the hole that gives the best t. See gure 3.

NOTE: Most tractors use the fourth hole from the end.

• Attach the assembled cross tubes to the right and left base tubes using two 1/4" x 1-1/2" hex bolts (B) and

two 1/4" nylock nuts (D). Tighten all bolts. See gure 3.

1/4" X 1-1/2" HEX BOLT (B)

INNER CROSS TUBE

FIGURE 3

OUTER CROSS TUBE

1/4" NYLOCK NUT (D)

1/4" X 1-1/4" HEX BOLT (A)

1/4" NYLOCK NUT (D)

• Insert the upright tubes onto the right and left base tubes, turning the upright tubes so that the small hole

shown in gure 4 faces inward. Fasten using two 1/4"

x 1-1/4" hex bolts (A) and two 1/4" nylock nuts (D).

See gure 4.

UPRIGHT TUBE

1/4" x 1-1/4" HEX BOLT (A)

SMALL HOLE

1/4" NYLOCK NUT (D)

• Unfold sun shade and locate the nylon loops found on the mesh portion of the sun shade. The mesh is

located at the rear. See gure 6.

• Hold the sun shade in front of the top tubes and slip the nylon loops onto the ends of the top tubes. Slide the sun shade along the top tubes, inserting the ends of the tubes into the stitched sleeves on each side of the sun shade. Continue until the ends of the tubes are pushed all the way to the ends of the sleeves.

See gures 6 and 7.

SLEEVE

FIGURE 4

• Attach top tubes to the upright tubes, but do not

install mounting bolts at this time. See gure 5.

• Attach rubber caps onto the ends of both top tubes.

See gure 5.

RUBBER CAPS

HOLES ON INSIDE

TOP TUBES

UPRIGHT TUBES

NYLON LOOP

FIGURE 6

• Install the shorter support rod with the attened

sections into the holes at the front of each top tube. Slits in the stitched sleeves provide access to the

holes in the top tubes. See gure 7.

SUPPORT ROD

FIGURE 5

FIGURE 7

• Fasten top tubes to upright tubes using two 1/4" x 1-1/4" hex bolts (A) and two 1/4" nylock nuts (D). See

gure 8.

• Insert one end of the remaining support rod into the small hole in one of the upright tubes. Insert the other end of the support rod into the small hole in the

other upright tube. It will be necessary to ex the rod

slightly so it can be inserted in the second hole. See

gure 8.

SUPPORT ROD

1/4" X 1-1/4" HEX BOLT (A)

1/4" NYLOCK NUT (D)

FIGURE 8

• Insert the small loop of the spring hook through the

hole at one end of the tarp strap. See gure 9.

• Insert an S-hook through the other end of the tarp

strap. See gure 9.

• Hook the spring hook over the end of the cross tube and attach the S-hook to the bottom edge of the

tractor fender. See gure 9.

• Repeat above steps for other tarp strap. Attach to

opposite end of cross tube. See gure 9.

CROSS TUBE

SPRING HOOK

TARP STRAP

TRACTOR FENDER

S-HOOK

FIGURE 9

OPERATION

Read this owner's manual and safety rules before operating your tractor with the sun shade.

CAUTION: This sun shade does not provide

protection against exhaust fumes, collision, rollover or other accidents.

CAUTION: Watch out for low tree limbs and other overhead objects which may interfere with the sun shade.

CAUTION: Never transport the tractor in an open truck or open trailer while the sun shade is attached.

• Check the area of operation thoroughly before using

the tractor with the sun shade . The added height of

the sun shade and a reduced eld of vision require

extra caution during operation.

• Remove the upper sun shade frame and canopy be-

fore you transport the tractor in an open truck or open trailer.

MAINTENANCE/STORAGE

CUSTOMER RESPONSIBILITIES

• Read and follow the maintenance schedule and the maintenance procedures listed in this section.

MAINTENANCE SCHEDULE Fill in dates as you

complete regular service.

Check for loose fasteners

Cleaning

Before each use

After each use

X X

Before storage

Every season

Service Dates

CHECK FOR LOOSE FASTENERS

• Before each use, make a thorough visual check of the sun shade for any bolts and nuts which may have loosened. Retighten any loose bolts and nuts.

CLEANING

• Wipe loose dirt and debris from the vinyl canopy after each use. The vinyl canopy can be washed using mild liquid soap and water.

STORAGE

• Clean the vinyl canopy thoroughly with mild liquid soap and water. Allow canopy to dry before storing.

• Store the sun shade in a clean, dry area away from direct sunlight.

PARTS

REPAIR PARTS FOR MODEL 486.24226 SUN SHADE

REF. PART QTY. DESCRIPTION NO. NO.

1 49279 1 Shade, Top 2 49310 2 Cap, Rubber 3 25352 1 Rod, Support (Short) 4 49277 2 Tube, Top 5 1509-90 5 Bolt, 1/4" x 1-1/4" 6 47189 7 Nut, 1/4" Nylock 7 49305 1 Rod, Support (Long) 8 49278 2 Tube, Upright 9 25357 2 Spacer 10 43840 2 Bolt, 5/16" x 1-1/4"

REF. PART QTY. DESCRIPTION NO. NO.

11 43648 2 Bolt, 1/4" x 1-1/2" 12 49274 1 Tube, Base (Right) 13 49284 1 Tube, Base (Left) 14 49288 2 Sleeve, Foam 15 49276 1 Tube, Outer Cross 16 49275 1 Tube, Inner Cross 17 49245 2 Hook, Spring 18 49313 2 Strap, Trap 19 44849 2 S-Hook 49290 1 Owner's Manual

91011

® Registered Trademark / TM Trademark /SM Service Mark of Sears Brands, LLC ® Marca Registrada /

Marca de Fábrica / SM Marca de Servicio de Sears Brands, LLC

Get it fixed, at your home or ours!

Your Home

For repair – in your home – of all major brand appliances,

lawn and garden equipment, or heating and cooling systems,

no matter who made it, no matter who sold it!

For the replacement parts, accessories and

owner’s manuals that you need to do-it-yourself.

For Sears professional installation of home appliances

and items like garage door openers and water heaters.

1-800-4-MY-HOME

(1-800-469-4663)

Call anytime, day or night (U.S.A. and Canada)

www.sears.com www.sears.ca

Our Home

For repair of carry-in items like vacuums, lawn equipment,

and electronics, call or go on-line for the location of your nearest

Sears Parts & Repair Center.

1-800-488-1222

Call anytime, day or night (U.S.A. only)

www.sears.com

To purchase a protection agreement (U.S.A.)

or maintenance agreement (Canada) on a product serviced by Sears:

1-800-827-6655 (U.S.A.) 1-800-361-6665 (Canada)

Para pedir servicio de reparación

a domicilio, y para ordenar piezas:

1-888-SU-HOGAR

(1-888-784-6427)

Au Canada pour service en français:

1-800-LE-FOYER

(1-800-533-6937)

www.sears.ca

Craftsman Sun Shade User Manual

Specifications and Main Features

Frequently Asked Questions

User Manual