Craftsman 706.101320, 706.101380 User Manual

OPERATOR’S MANUAL

Workbench

Please indicate the following information from the service part drawing provided. Model Number: ____________________________ Model Description: _________________________ *Product you purchased may vary from picture shown. Caution: Read and follow all Safety Rules and Operating Instructions before first

use of this product. Retain this document for future reference. Sears, Roebuck and Co., Hoffman Estates, IL 60179, USA

F1649

SAFETY

SAFETY WARNINGS AND CAUTIONS:

• Use appropriate safety equipment when using power and hand tools. Failure to do so may cause personal injury or product damage.

• Use adequate manpower when assembling and moving this unit. Failure to do so may cause personal injury or product damage.

• DO NOT stand on this product. You may fall which may cause personal injury.

• DO NOT mount this product on a truck bed or any other moving object. This may cause personal injury or product damage.

• Appropriately secure this product before moving it with a forklift.

• DO NOT alter this product in any manner. For example, do not weld external lockbars or attach electrical equipment. This may cause product damage or personal injury.

• Keep the product on level surfaces. The product may become unstable and tip if stored or moved on an un-level surface, which may cause personal injury or product damage.

• DO NOT step in the drawers. You may fall which may cause personal injury.

• Maximum combined weight limit not to exceed 1,450 pounds. If the limit is exceeded, the product could collapse and cause personal injury or product damage.

Tools Required:

Socket wrench 3" socket extension 7/16" Deep-well Socket 3/8" Wrench Drill 1/8" Drill bit Square Tape measure

Hardware Included

AA(12)

BB(12)

CC(12)

DD(11)

B (3)

A (2)

EE(4)

Call 1-800-4MY-HOME (1-800-469-4663) for Service Parts.

Refer to Service Parts Drawing for full listing of Service Parts.

ASSEMBLY

STEP (1):

AA(8) BB(8) CC(8)

STEP 2:

AA(4)

BB(4)

CC(4)

EE(4)

• Assemble (2) (EE) in each (A). Some adjustments may be necessary after workbench is in desired position.

• Place workbench top, (D) with coated side down. (Use packaging material to prevent scratches.

Note: The rail (B) with the label should be placed toward the front of the unit with the label upside down.

• Assemble (2) (A) and (2) (B), as shown, using (8) (AA), (8) (BB), and (8) (CC). Flanges of (B) should point in. Notches should be up.

• Finger tighten.

(EE) on top

• Attach remaining (B) in top back set of holes in (2) (A) as shown, using (4) (AA), (4) (BB), and (4) (CC). Flanges of (B) should point out.

• Finger tighten.

CC BB

Flanges point out

Front

Back

• Square the unit and wrench tighten all fasteners.

Front

CC BB

Back

Notches on top

Flanges point in

+ 5 hidden pages