Coyote CCDWD Instructions
CCD-WD INSTALL GUIDE
DIMENSIONAL RENDERINGS
42 1/8"
20 3/4"
10 1/4"
OPENING HEIGHT
INCLUDING
COUNTERTOP
20 3/4"
OVERALL
HEIGHT
19 1/2"
FRONT VIEW
GRILL OPENING WIDTH
40 5/8"
CUTOUT WIDTH
42 1/8"
OVERALL WIDTH
26 1/2"
25 1/4"
1 1/2" MIN
SUGGESTED
FOR
FRAMING
19 1/2"
CUTOUT
HEIGHT
25 1/4"
INTERIOR
DEPTH
1 1/4"
EXTERIOR
DEPTH
TOP VIEW
40 5/8"
CUTOUT WIDTH
42 1/8"
OVERALL WIDTH
40 5/8"
Overall Product Dimensions
Model No. Height Width Depth
CCD-WD
Install Notes:
2 anchor points are located on each side of the doors interior frame (top, bottom, left and right)
Due to wide variance of possible building materials, anchors are not included
When inserting your anchors be sure to use a framing square to ensure the door is not pulled out of square
Additional framing and/or support underneath the rear (hanging portion) of the cabinet is recommended
These specs are accurate but we always suggest having the product physically on site to ensure full understanding of how this product
will coordinate with your build
Electrical Requirements:
20 3/4"
42 1/8"
26 1/2"
Model No. Height Width Depth
CCD-WD
Cutout Dimensions for Island
19 1/2"
40 5/8"
25 1/4"
This refrigerator must be installed in accordance with National Electric Codes, as well as state, municipal and local codes
The correct voltage, frequency and amperage must be supplied to the refrigerator from a grounded circuit which is protected by a
properly sized
circuit breaker or time delay fuse.
The proper voltage, frequency and amperage ratings are listed on the product rating plate.
The warming drawer must be properly grounded at all times when electrical power is applied.
Never allow any debris to build up underneath, or in front of the unit, blocking ventilation.
Im
portant Note to Installer: This file is not intended to replace your Owners' Manual which contains specific safety requirements and
consumer guidelines. Please refer to your Owners' Manual prior to installing or operating your built-in warming drawer.
www.coyoteoutdoor.c
Loading...