Cortelco 1201 User Manual
SAFETY INSTRUCTIONS
4
To reduce the risk of fire, electrical shock, and injury, please follow
these basic safety precautions before youuse this equipment.
1.
Carefully read the instructions in this manual.
2.
Follow all warnings and instructions marked onthe unit.
3.
When cleaning, unplug the telephone jack from the wall outlet. Use
a damp cloth. use liquid or aerosol cleaners.
Do not use this equipment near water, eg: near a kitchen sink,
4.
bathtub, washbowl, laundry rub, swimming pool or in a wet
basement.
Install in a protected location. Ensure all lines and cords are away
5.
from foot traffic. place objects on the line cord that may
cause damage or abrasion.
Avoid spilling any liquid on the unit. This may cause internal
6.
shorting, fireor shock and is not coveredunderyourwarranty.
Do not overload wall outlets and extension cords as this can result
7.
in the risk of fire or electrical shock.
Never push objects of any kind into this telephone as they can
8.
touch dangerous voltage points or short out parts that could result
in a risk of fire or electrical shock.
9.
Take the phone to a qualified technician when it requires repair
work or service. To reduce the risk of electrical shock, do not
disassemble the telephone. Opening or removing covers can
expose you to dangerous voltages or other risks. Incorrect reassembly can cause electricalshock during subsequent use.
Avoid using the telephone during an electrical storm. There can be
10.
a slight risk of electrical shock from lightning.
11.
DO NOT
the leak.
Unplug this telephone from the wall outlet and refer servicing to
12.
qualified service personnelunderthefollowingconditions:
l
If liquid is spilled into the unit.
l
If the unit is exposed to rain or water.
l
If the unit does not operate normally by following the
operating Instructions.
l
If the unit is dropped or the casing is damaged.
l
If the unit exhibits a distinct change in performance.
DO NOT
DO NOT
use the telephone to report a gas leak, if in the vicinity of
7
O
WNER'S
NSTRUCTION ANUAL
IM
MODEL 1201
LOCATION OF CONTROLS
1
Hook Switch
Handset
LCD display
Volume
Message lamp
VOL.
VOL.
PAUSE
WALL INSTALLATION
3
1.
Slide the handset tab out and rotate it 180 degrees so that the hook
points up. This will hold the handset in the cradle when the phone is
mounted on the wall.
Remove the desk stand from the phone base (see diagram 2).
Memory
(M1~M3)
RING
STORE/SET
STORE/SET
M1
M2
M3
PAUSE
FLASH
AUTO
AUTO
MUTE
MUTE
HOLD
HOLD
REDIAL
REDIAL
2.
Mount the phone on a standard telephone wall jack.
3.
Desk tab
position
Wall mount
tab position
diagram 1
diagram 2
FLASH
1
6
Loading...