Cornelius PR150-300, IP150 User Manual

PR150/300 and IP150 Separate Drain for Upper Driptray Installation Instructions

INSTALLATION INSTRUCTIONS

PR150/300 & IP150 Separate Drain for Upper Driptray

1. Raise and lock driptray assembly (see
FIGURE 1).

Driptray Assembly

FIGURE 1

2. Clean out and dry driptray with a rag or paper towel, remove strainer if applicable (see FIGURE 2
and FIGURE 3).

Strainer

Upper Driptray Assembly

FIGURE 2

Clean and Wipe Dry Inside Driptray

FIGURE 3

3. Remove insulation from driptray drain line
assembly (see FIGURE 4).

Remove Insulation from Driptray

Drain Line Assembly

Release Date: December 10, 2004 www.cornelius.com Revision: B
© 2004, IMI Cornelius Inc. - 1 - Publication Number: 629088497INS

FIGURE 4

PR150/300 and IP150 Separate Drain for Upper Driptray Installation Instructions

4. Cut PVC drain as shown in FIGURE 5. BE

CAREFUL TO SECURELY HOLD DRAIN LINE
TO AVOID DAMAGE TO UPPER DRIPTRAY!!!

5. Deburr edge of PVC and re-plumb and clamp with
new flexible tube/clamp supplied in kit (see
FIGURE 6). MAKE SURE THAT THE

INSULATION COVERS ALL EXPOSED
TUBING/CLAMP!

Cut PVC Drain

FIGURE 5

Clamp Drain Line

Re-plumb with New Drain

Line and Insulation

FIGURE 6

6. Re-route new drain tube to floor drain. MAKE SURE THAT THERE ARE NO KINKS IN NEW
DRAIN LINE!

7. Re-install driptray strainer if applicable.

8. Check driptray, fittings, and lines for leaks.

9. Lower upper driptray assembly.

Publication Number: 629088497INS - 2 - © 2004, IMI Cornelius Inc.