Cornelius P-N 631500074, P-N 631500099, P-N 631500108, P-N 631500109, P-N 631500116 User Manual

IMI CORNELIUS INC g One Cornelius Place g Anoka, MN 55303-6234

Telephone [phone] Facsimile [phone]

INSTALLATION INSTRUCTIONS, BIN STAT KIT, P/N 631500074,
631500099, 631500108, 631500109, AND 631500116

These Bin Stat kits apply to all “X” Series Ice makers

Table 1. Loose–Shipped Parts

Item No. Part No. Name Qty.

1 630000837 Thermostat Asy 1
2 07578 Screw TC 08–32 2
3 630460162 Installation Instruction, Thermostat 1
4 630900895 Hex Nut 8–32 SS Keps 1
5 620045454 or

620045455 or
620045456 or
620045457 or
620050327

Bin Stat Support 1

1. Disconnect power.

2. Remove front cover of the unit and the electrical box cover plate. For 22” wide units you will need to
remove the Grill from the right side of the unit.

3. To mount bin thermostat in electrical box:

A. Route wires and connector through grommet in electrical box (see Figure 1).

B. Attach bin thermostat to electrical box with two 08–32 TC screws provided (see Figure 1).

4. Connect the bin thermostat lead to the circuit board (see Figure 2).

5. Straighten approximately 12” of capillary tube to go through hole in chassis base. Re–coil the re­mainder. Do not disturb the tightly coiled end.

6. Insert the “1/4” diameter wire Bin Stat support into the coiled end of capillary tube. Carefully wrap 5
turns of free capillary tube tightly around the Bin Stat support. Insert the assembly through the hole
in the chassis base. Route capillary tube to follow the Bin Stat support as closely as possible (see
Figure 3).

7. Slip eye of Bin Stat support over the 8–32 weld stud in the chassis base. If a nut exists on this weld
stud remove before assembling the Bin Stat support. Secure the Bin Stat support with the 8–32
Keps nut provided in the kit (see Figure 3).

8. Any excess capillary tubing must be carefully pulled back into the compressor compartment to pre­vent ice from damaging it during dispenser operation.

IMI CORNELIUS INC. 2001–2003

October 9, 2003

6304601621

Rev C

9. Seal ½” diameter hole with sealant (RTV).

10. Turn bin stat adjustment screw clockwise until it stops. Then turn it counterclockwise 1/8 of a turn.

11. Reinstall the front cover of the electrical box and the ice machine and reconnect the power. Verify
that the Bin Stat is working by holding ice on the coiled bare capillary tube. The bin stat will allow the
ice machine cycle to complete and harvest ice. Then the ice machine will shut down. Remove the ice
from the capillary tube and warm the tube with hand heat. The ice machine should start in approxi­mately 60 seconds. Reinstall front cover and grill (22” units only).

ELECTRICAL BOX ASY

SCREW TC 08–32

TO CHASSIS BASE

IMI CORNELIUS INC. 2001–2003

TO CIRCUIT BORD

THERMOSTAT KIT ASY

631500074

COIL

Figure 1

October 9, 2003

6304601622

Rev C