Cornelius P-N 629088756 User Manual

IDC 255 Icemaker Adaptor Kit Installation Instructions

INSTALLATION INSTRUCTIONS

IDC 255 ICEMAKER ADAPTOR KIT FOR P/N 629088756
(

FOR HOSHIZAKI KITS)

Icemaker Adaptor Kit

Bar

Cross Braces

FIGURE 1

1. Place bar into first set of pockets inside the ice bin.

2. Hook cross braces over top of bar and place into outer pockets inside the ice bin (at back end).

3. Place the icemaker adaptor kit on top of unit.

Revision Date: February 23, 2006 www.cornelius.com Revision: A

© 2006, IMI Cornelius Inc. - 1 - Publication Number: 629088756INS

IDC 255 Icemaker Adaptor Kit Installation Instructions

4. Place the icemaker on top of kit and adjust it so that only 3.096” of it protrude outside the IDC
wrapper, as shown in FIGURE 2. DO NOT slide icemaker into position on the lid.

3.096

FIGURE 2

5. Apply a continuous bead of NSF International (NSF) listed silastic sealant (Dow 732 or equivalent),
supplied in kit to seal the icemaker to the top of the adapter kit. All excess sealant must be wiped
away immediately.

6. Secure the icemaker to the adapter by drilling 9/64” diameter holes, using one of the two brackets
supplied in the kit, into both the rear of the icemaker and rear of the icemaker adapter kit. Use
extreme care not to drill into any icemaker components!!! Secure the brackets using the screws
provided.

7. For optimal performance, do not fill ice bin more than 2/3 capacity (maximum fill is 4” below top of
bin). Applies to IDC 255 models and nugget ice only.

NOTE: Adaptor kits are only approved for top mounting a single icemaker.

Publication Number: 629088756INS - 2 - © 2006, IMI Cornelius Inc.