Cornelius Flavor Fusion Installation Manual

FlavorFusion Icemaker Adaptor Kit Installation Instructions

!

WARNING:

!

WARNING:

Cross
Braces

Bar

Cross
Braces

Bar

INSTALLATION INSTRUCTIONS

FLAVORFUSION ICEMAKER ADAPTOR KIT FOR P/N 629097219

Disconnect power to the unit before installing adaptor following all lock out / tag out procedures established by the
user. Verify all of the power is off to the unit before performing any work. Failure to comply could result in serious
injury, death or damage to the equipment.

All of the attachment screws and plates must be installed as directed in this manual. Failure to comply could result in
serious injury, death or damage to the equipment.

1. Place bar into first set of pockets inside the
hopper.

2. Place ice maker rail supports into the pock­ets in the ice bin as shown in Figure 1.

3. Hook cross braces over top of bar and
place into inner pockets inside the hopper
(see Figure 2).

4. Place Icemaker Adaptor Kit on top of dis­penser.

NOTE: Picture may not match your
adaptor model.

Figure 1

Figure 2

Revision Date: March 27, 2014 www.cornelius.com Revision: B

© 2013-2014, Cornelius Inc. - 1 - Publication Number: 629097219INS

FlavorFusion Icemaker Adaptor Kit Installation Instructions

Rear of Dispenser

Manual Fill
Cover

Icemaker

Adapter
Lid

Manual Fill Cover

Icemaker

Icemaker Mounting
Brackets

Front of Dispenser

5. Place icemaker on top of the adapter lid
(see Figure 3). Dimensions in Figure 3 are
to aid in installation only. Be sure that the
icemaker ice drop tubes are clearly within
the adapter lid opening. Failure to do so
may cause damage to icemaker.

6. Apply continuous bead of NSF international
(NSF) listed silastic sealant (Dow 732 or
equivalent), to seal the icemaker to the top
of the adapter lid. All excess sealant must
be wiped away immediately.

7. Install the icemaker mounting brackets as
shown in Figure 4. Using the brackets as a
template, drill .136 diameter (#29 drill size)
holes into the icemaker cabinet and the
adapter lid. Use care not to drill into any
icemaker components (condenser, tubing,
etc.). Secure the brackets using the #10
sheetmetal screws provided.

8. Follow the icemaker manufacturer’s instruc­tions to complete the installation of the ice­maker including the bin thermostat.

9. Secure the manual ice fill cover in position
on the lid over the rear hopper access
opening with thumb screw. Note that the
gasket should be compressed to form a
seal against the icemaker cabinet with the
cover secured in position

Figure 3

NOTE: Bracket location will
depend on ice maker model.

10. Reconnect electrical power to the dis­penser.

11. Verify the function and operation of both the
icemaker and dispenser.

Figure 4

Installation is complete. For optimal
performance, do not fill ice bin more
than 2/3 capacity (maximum fill is 4”
below top of bin).

Publication Number: 629097219INS - 2 - © 2013-2014, Cornelius Inc.