Issue 4a 25/08/2021  4 
TO USE THE KETTLE 
This kettle can be used to heat water to a variety of 
temperatures, ideal for the preparation of some fruit and 
speciality teas that are best prepared at lower temperatures.  
The kettle can also keep water at the selected temperature up to 
30 minutes if desired. 
1. Place the kettle and stand on a stable, flat, heat resistant 
surface and away from surfaces that may be damaged by 
steam. 
2. Fully unwind the cable, plug in and switch on at the mains, a 
bleep will be heard and the indicators will briefly illuminate.  
For safety do not allow the cable to dangle over the edge of 
units. 
3. Remove the kettle from the stand; press the lid button to 
open the lid. Fill to the required level using the graduated 
markings on the glass body as a guide. Do not fill past the 
maximum (1.7 litre / 7 cups) or below the minimum (0.5 litre 
/ 2 cups) level. 
4. Close the lid fully (it clicks as it closes), replace the kettle on 
the stand and turn the kettle so that the spout faces away 
from you. 
•  To boil the kettle, press the ON / OFF ( ) button. The 
indicators in the on/off and 100˚C buttons will 
illuminate.  
•  To heat water to 90, 80 or 70˚C, press the on /off button 
and then press the temperature button of choice.  The 
indicators in the ON/OFF ( ) and temperature button of 
choice will illuminate. 
•  To keep the water at the selected temperature, follow 
direction above and then press the KEEP WARM button 
before the kettle reaches the desired temperature. The 
indicator in the button will flash to show that this mode 
has been selected.