Convair Millenia, Megacool User Manual
OWNER’S MANUAL
Portable Evaporative Cooler
MASTERCOOL
(MIC, MICH)
IL L8 63- A
MEGACOOL
(MIV, MIVH)
®
ILL1222-A
IL L8 63- A
MILLENIA
(English) (MI MIH MIC MICH MIV MIVH)
(MI, MIH)
CONTENTS
SAFETY........................................................................ 1
General Safety
Electrical Safety
COMPONENT LOCATION........................................... 2
ASSEMBLY.................................................................. 3-4
Caution - Check Voltage
To assemble the cooler
DIRECTIONS FOR USE.............................................. 4-6
How to get the best cooling performance
Filling with water
Using the cooler - Low fan speed
High fan speed
Fan only (vent)
Conditioning of Aspen cooling pads
Air direction control
Safety instructions
Cleaning the cooler/rear panel removal
MAINTENANCE.......................................................... ..6-7
To drain water
Water strainer and Aspen cooling pad
Pump belt replacement / Drain Plug
TROUBLESHOOTING..................................................8
SPARE PARTS LIST & EXPLODED VIEW..................9-10
WARRANTY................................................................ . 11
Waste electrical products must not be disposed of with household waste. This product
should be taken to your local recycling centre for safe treatment.
®
i
Millenia series Portable Evaporative Cooler
SAFETY
Portable evaporative air cooler important safety instructions
Please read these instructions before
assembling the cooler and keep for future
reference.
This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless
they have been given supervision or
instruction concerning use of the appliance by
a person responsible for their safety.
Children should be supervised to ensure that
they do not play with the appliance.
General Safety
For indoor use only.
Use only in the upright position on a flat level
surface and at least 50cm from any objects.
Clean the air inlets and outlets at regular
intervals to prevent airflow reduction (refer
Maintenance section).
Do not place objects on the air cooler, or
through the ventilating slots or restrict the air
inlets & outlets.
Electrical Safety
Caution! before connecting the electrical
power cord to a power outlet, check that
the air cooler voltage is the same as your
power supply (refer to the rating label
located on the rear of the unit).
Do not pull the unit along by the power
cord or place the power cord near a
source of heat. Always unroll the power
cord completely before use.
If the power supply cord is damaged it
must be replaced by the manufacturer, a
service agent or qualified similarly
persons in order to avoid a hazard.
Switch off and unplug when not in use.
Closely supervise any children and pets when
the air cooler is in use.
Do not store or operate the appliance near
any flammable substances.
During operation, water is present in the
bottom tank of the air cooler. Be careful when
moving the unit to prevent water from spilling.
Always switch your cooler off and unplug it
before cleaning or maintenance.
SEELEY INTERNATIONAL – OWNER’S MANUAL 1
COMPONENT LOCATION
KEY
A Controls
B Front grille
C Water filling door
D Water reservoir
E Castors
F Water level indicator
G Front pillar ( llenia, Megacool)Mi
H Base
I Rear panel retaining screws (2)
J Rear panel
K Power cord entry point
L Reservoir drain plug
M Rating label
N Cord storage hooks
O Rear pillar ( llenia, Megacool)Mi
A
B
C
D
E
®
2
Millenia series Portable Evaporative Cooler
F
G
H
IL L8 64- A
I
J
K
L
M
N
O
IL L8 65- B
ASSEMBLY
CAUTION! - Check Voltage
Before connecting your electrical power
cord to a power outlet, check that the
cooler voltage is the same as your power
supply. The cooler voltage will be stated
on the rating label at the rear of the
cooler (Fig 6).
6
IL L8 66- A
To assemble the cooler
Push the four castors into their locating
holes in the base. Use a rotating motion
to assist in the entry of the steel spring
ring (“ ” Fig 7).
*
Models llenia and Megacool onlyMi
Assemble the front and rear pillars and
screw together. Place this assembly on
the base and slide into position until it
locks (Fig 8).
Models llenia and Megacool onlyMi
Place the reservoir of the cooler onto the
front pillar as shown (Fig 9). Tilt
downwards towards the rear until the
reservoir locks onto the rear pillar.
To remove the unit from the pillars, use a
screwdriver in the two recesses in the
rear of the reservoir to release the clips.
Tilt the unit forward to remove.
7
*
ILL867-B
8
ILL 1221- A
9
ILL 870-A
SEELEY INTERNATIONAL – OWNER’S MANUAL 3
Loading...