Convair CTH08 User Manual

OWNER’S MANUAL

Convair Tower Heater CTH08

ECO

1h

2h

4h

8h

14°

18°

22°

26°

(English) (CTH08)

SAFETY

General Safety

Please read these instructions before using the
heater and keep for future reference.

This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they
have been given supervision or instruction in
using the appliance by a person responsible
for their safety.

Children should be supervised to ensure that
they do not play with the appliance. Do not
poke anything through the ventilating slits.

Always use the heater in an upright position.

Stand it on a rm, solid, horizontal base (not on

thick pile carpets).

WARNING: In order to avoid
overheating, do not cover the
heater.

Leave nothing hanging above or in front of
the heater (e.g. clothes, curtains, bedding,
fabrics). Be sure that the back panel vent
slots on the heater are uncovered otherwise it
will overheat. Clean these openings at regular

intervals to prevent airow reduction (refer

Maintenance section).

The heater surfaces are hot when in use. To
avoid burns, keep bare skin away from the
top ventilation outlets. Leave plenty of room
around the heater.

Do not use this heater outdoors, or on
wet surfaces. Do not use the heater near

ammable areas or substances.

Electrical Safety

Connect the heater to a single 230 Vac, 10A
socket only. Do not plug into double adaptors
or multi-outlet power boards. Do not use an
extension cord to operate this heater.

Make sure that the heater never comes into
contact with water. Never position the heater
under a power outlet.

Never turn the heater on if the power supply
cord is damaged or if the heater’s casing
is obviously damaged. If the power supply
cord is damaged it must be replaced by the
manufacturer, a service agent or similarly

qualied persons in order to avoid a hazard.

Do not pull the heater along by the power cord
or place the cord near the heater’s surfaces.
Always uncoil the power cord completely
before use. Use of extension cords is not
recommended.

Do not use this heater in the immediate
surroundings of a bath, a shower or a
swimming pool. If the heater is to be used in
a bathroom, ensure that switches and other
controls cannot be touched by a person in the
bath or shower.

Do not use this heater with a programmer,
timer, separate remote-control system or
any other device that switches the heater on

automatically, since a re risk exists if the

heater is covered or positioned incorrectly.

Always turn the heater off and unplug from the
power socket when not in use.

Safety Device

To avoid overheating problems the inbuilt
safety device will interrupt electricity in the
event of the heater overheating.

If this should happen:

• Check that the heater is positioned
correctly, not close to any furnishings.

• See that there is no dust or other obstacles
blocking the vent slots.

• Clean the vent slots if necessary.

The heater is also equipped with a ‘tip-over’
switch, which will turn off power to the heater
elements if it should fall over.

1

|

TOWER HEATER - CTH08

ASSEMBLY

COMPONENTS LIST

ECO

1h

2h

4h

8h

14°

18°

22°

26°

ASSEMBLY

1

Unpack the heater components and check that
you have all of the components.

2

Turn the heater upside down and remove

3

the plastic Locking nut. Assemble the Base
onto the heater and lock into position with the
Locking nut.

4

Note: Ensure the nut is tight to avoid shaking
of the heater.

REMOTE

When the heater power is on, the remote

5

control can be used to operate the heater from
up to 4m away.

If there are two or more heaters within this

6

7

distance all will be operated by the same
remote control.

Replacing the battery

Release battery slide by pressing on the tab at
the bottom of the remote. Remove the battery

11

8
9

and replace with an equivalent CR2032 type
battery.

Note: Your remote control will be supplied with
a battery.

10

1. Control panel

2. Display Panel

3. Body sensor

4. Front Grille

5. Handle

6. Remote holder

7. Air inlet grille

8. Power Isolation Switch

9. Base (Locking nut not shown)

10. Mains power cord

11. Remote control

OWNER’S MANUAL | 2