Contel Electronics Technology WN7122G User Manual

IEEE 802.11n
Wireless USB 2.0 Adapter
User’s Guide

WN7122G
2011-5-17
R01

Trademarks:

Other product and company names are trademarks or registe red trademarks of their

respective holders.

COMPLIANCES

Federal Communication Commission Interference
Statement

This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this
equipment.

IMPORTANT NOTE:
FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.

2.4GHz operation of this product in the U.S.A. is firmware-limited to channels 1
through 11.

COMPLIANCES

ii

IC Statement

This device complies with RSS-210 of the Industry Canada Rules.
Operation is subject to the following two conditions:

1) this device may not cause interference and

2) this device must accept any interference, including interference that may cause
undesired operation of the device
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numerique de la class B est conforme a la norme NMB-003 du
Canada.

IMPORTANT NOTE:
IC Radiation Exposure Statement:

This equipment complies with Canada radiation exposure limits set forth for
uncontrolled environments. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.

2.4GHz operation of this product in Canada is firmware-limited to channels 1
through 11.

1

802.11N WIRELESS
USB ADAPTER

The 802.11N Wireless USB Adapter (WN7122G) is
another cutting edge introduction in 2.4GHz wireless
communication for 11n wireless network connection. Designed
for both the home and office, this wireless USB2.0 adapter