Contel Electronics Technology BT200 User Manual

Pow er On/O ff

LED Lights

Answer/Hang Up/

Play/Pause

Microphone

Volume+

Volume-

Micro-USB Port

Microphone

1 2

The microphone on your speaker is right

below the hook. Talk into that during phone

calls. The microphone is useful for group

or conference calls when there are more

than one person.

3

4

Use the hook to attach the speaker to

a

o

different things. You can hook onto bags,

purses, clothing or any place you can

hang the speaker. Use the speaker for

handsfree calling as well.

5 6 7 8

FCC Statement

1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.

2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reason

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio

This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio c

frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there

Reorient or relocate the receiving antenna.

is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,

Increase the separation between the equipment and receiver.

which can be determined by turning the equipment off and on, the user is encouraged to try correct the interference by one or more of the following

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

measures:

Consult the dealer or an experienced radio/TV technician for help.

- Reorient the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into and outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.