Page 1
Solar Power Ethernet Kit for Remote Locations
15 Watts Continuous Power System with 3 Hours of Peak Sunlight
NWKSP2
803.2afBATTERIES
INCLUDED
The NetWave® NWKSP2 Solar off the grid power system is designed for applications where
a remote camera or wireless repeater is needed but power is not available or the cost to run
power is too expensive. NetWave Solar is a complete system for providing remote power to
edge communications equipment. The kit includes high quality photovoltaic solar panels,
valve-regulated lead-acid battery, outdoor enclosure, solar charge controller, PoE midspan
injector and mounting hardware. The steel outdoor enclosure has a gasket hinged lid with two
tamper proof locks operated by a special key for high security. The enclosure can be mounted
on a two to four inch pole or wall mounted with the included mounting hardware. The Solar
Panels include a top of pole mount requiring a 4” diameter pole. A side of pole mount is
available as an optional accessory. The included 30A solar charge controller supports an LCD
screen for local diagnostics and system health monitoring, Intelligent PWM charging mode and
battery protection from overcharge and over discharge while the battery provides outstanding
deep cycle and cold weather performance.
FEATURES
› Warranty: 1 Year on Battery
2 Years on Solar Panels and Hardware
› Solar panels are designed with heavy duty anodized frames
that are capable of withstanding high wind pressure, hail and
snow load.
› Solar Panels feature outstanding low light performance
› Two High Efficiency Multicrystalline Photovoltaic Solar Panels
› Weatherproof powder coated steel enclosure that meets
NEMA 4X/IP65 weatherproofing standards
› Valve Regulated Sealed Lead Acid AGM Battery with great
low temperature performance to -40ºC
› 12 VDC Solar Charge Controller with LCD Screen, Intelligent
PWM Charging Mode, Adjustable charging and discharging
parameters
› 48 VDC Gigabit PoE Injector
› Intelligent Controller Featuring:
• Solar Controller Diagnostics LCD Display Supporting
Readout of Several Parameters Including System Charge/
Discharge and Battery Voltage
• Ampere Hours Monitoring of Accumulated Charge/
Discharge
• Intelligent PWM Charge Controller
• Automatic Temperature Compensation
• Adjustable Charge/Discharge Control Parameters
• Battery Low Voltage Disconnection
• Battery Reverse Connection Protection
• Overload/Short Circuit Protection
APPLICATIONS
› Remote Surveillance Cameras
› Wireless Perimeter Surveillance
› Temporary Network Surveillance Deployments
› Construction Site Network Access
LIMITED WARRANTY WWW.COMNET.NET TECH SUPPORT: 1.888.678.9427
Page 2
NWKSP2
SPECIFICATIONS
Solar Power Ethernet Kit for Remote Locations
15 Watts Continuous Power System with 3 Hours of Peak Sunlight
Controller
Controller Type 12 to 24 V Solar Charge Controller
Controller Self Consumption < 0.5 W
IEEE 802.3af Compliant Power Injector
Input 12 VDC
Output 48 VDC @ .35 A
Self Consumption 1 W
Solar Panels (QTY 2)
Maximum Power (Pmax) 120 W
Voltage at Pmax (Vmp) 17.2 V
Current at Pmax (Imp) 6.98 A
Open-circuit voltage (Voc) 21.6 V
Short-circuit current (Isc) 7.72 A
Temperature coefficient of Voc -(80±10)mV/ºC
Temperature coefficient of Isc -(0.065±0.015)%/ºC
Temperature coefficient of power -(0.5±0.05)%/ºC
NOCT¹ 47±2ºC
Operating temperature -40ºC to +85ºC
Maximum system voltage 1000 VDC
Power tolerance ±5%
Peak Sunlight 6 Hours
Battery Capacity 110 Ah
Battery Voltage 12 V
Reserve Time 40 Hours²
PoE Output Voltage 48 VDC
System Weight with Battery³ 260 lb (118 kg)
Mechanical
Enclosure Powder Coated Steel
Enclosure Size 24 × 15 × 14 in (60.96 × 38.1 × 35.56 cm)
Solar Panels 2 × 120 W Solar Panels
Solar Panel Size 48.98 × 26.57 × 1.38 in (124.4 × 67.5 × 3.5 cm)
Solar Panel Weight 24.25 lb / 11 kg
Environmental
MTBF >100,000 hours
Operating Temp -30° C to +60° C
Storage Temp -40° C to +85° C
Relative Humidity 5% to 95%
Warranty
Battery 1 Year
Solar Panels & Hardware 2 Years
[1] Nominal Operating Cell Temperature: Air 20ºC; Sun 0.8kW/m²;
Wind 1m/s
[2] Actual Reserve Time is condition-dependent.
ORDERING INFORMATION
Part Number Description
NWKSP2 15W continuous power solution requiring 3 hours of peak sun a day
Included Accessories Enclosure, Top of Pole mounting hardware for the Solar Panel, Controller, Midspan Injector and Cables
Options User selection of Industrially Hardened NetWave® Wireless Ethernet Units
[3] Add suffix ‘/NB’ to the part number you order if you wish to exclude battery from the kit
Side of Pole mounting hardware (Order ComNet Part NWHWP3, extra charge, consult factory)
TYPICAL APPLICATION
Solar Panels
Battery
–
–
PoE
Ethernet
NW7 PoE Camera
PoE
Ethernet
+
NWKSP2
Controller PoE Injector
+
LEGEND
WIRELESS
CAT5
POWER
ETHERNET
3 CORPORATE DRIVE
8 TURNBERRY PARK ROAD
© 2014 Communic ation Netwo rks. All Righ ts Reserv ed. “ComNet ,” the “Co mNet Logo,” “Ne tWave” and the “N etWave Logo” a re register ed trademark s of Communica tion Networ ks.
|
DANBURY, CONNECTICUT 06810
|
GILDERSOME
|
MORLEY
|
|
USA
T: 203.796.5300
|
LEEDS, UK LS27 7LE
|
F: 203.796.5303
|
T: +44 (0)113 307 6400
|
TECH SUPPORT: 1.888.678.9427
|
F: +44 (0)113 253 7462
|
INFO-EUROPE@COMNET.NET
|
INFO@COMNET.NET
06 Aug 2014
Loading...