INSTALLATION AND OPERATION MANUAL
CNFE100(X) Series
10/100 MBPS ETHERNET 2 PORT MEDIA CONVERTER 1 CHANNEL: ELECTRICAL OPTICAL
The CNFE100(X) converts 10/100 Mbps Fast Ethernet from an electrical signal to an optical signal and back to an electrical signal. The electrical connection uses an RJ45 data connector.
Depending on the specific model in use, the optical connector is either a ST or SC, 1 or 2 Fibers, multimode (M) or singlemode (S), and the unit operates on either AC/DC or DC only power.
The CNFE100(X) Series standard size units may be directly plugged into the ComNet Rack (Part C1) or operated as a standalone module. The CNFE100(X)-M small size units operate as standalone modules only.
See Figures 1 – 7 for complete installation details.
INS_CNFE100(X)_REV– 01/04/10 PAGE 1
INSTALLATION AND OPERATION MANUAL |
CNFE100(X) SERIES |
FIGURE 1 – CNFE100(X) SERIES STANDARD SIZE UNIT
MULTIMODE OR
SINGLE MODE
OPTICAL FIBER
BLACK
BLACK WITH WHITE STRIPE
FIGURE 2 – CNFE100(X) SERIES STANDARD SIZE UNIT
FRONT PANEL |
REAR PANEL |
NOTE: Remove Electrical Connector for Rack Mount Units
TECH SUPPORT: 1.888.678.9427
INS_CNFE100(X)_REV– 01/04/10 PAGE 2