Code Alarm CSI-200 User Manual

Model CSI-200

Owner’s Manual

3 Button Remote Security System with
Stage Shock Sensor & Starter Disable

FEA TURES :

 2 Four Button Code Hopping RF Transmitters
 Four Channel Code Learning Receiver (capable of accepting 4 transmitters)
 Selectable Manual Override Mode
 Remote Panic in all modes
 Protected Valet
 7 Function LED -(Light Emitting Diode) - Arm / Disarm / Zone1, 2, 3 / Valet / Arming
 Intrusion Alert with Memory
 Audible Arm / Disarm / Defective Zone / Tamper Confirmation
 Instant Siren Activation
 Low Current Horn Output
 Starter Disable
 True Last Door Arming (hardwire only)
 Defective Zone By - Pass
 Hardwire or Voltage Sense Selectable
 Active or Passive Arming Selectable
 Programmable Auto Lock On / Off
 Programmable Auto Unlock, Drivers Door All Doors On / Off
 Programmable Door Lock Pulse Duration 1 Second / 3.5 Seconds/1 Sec L/ Dbl. U/L
 Programmable Active or Passive Door Locks
 User Programmable Permanent Chirp Delete
 On Command RF Chirp Delete from Transmitter (Software Selectable)
 6 Tone Multi - Tone Siren
 Additional Negative Trigger Input
 RF Inhibit with ignition on
 Parking Light Flasher
 Plug In Dual Stage Shock Sensor

OPTIONS :

 Remote Trunk Release
 Remote Keyless Entry
 Illuminated Entry
 Multiple Vehicle Capable
 Remote Starter
 Remote Power Window Roll Up
 Remote Garage Door Interface
 Two Step Unlock Configurable

128-

1 of 8

NOTE: Your system has the option of using a siren, the vehicle horn, or both for the

ARMING THE SYSTEM - ACTIVE

1. Turn off the engine, exit the vehicle, and close all doors, hood lid, and trunk lid.

2. Press and release the ARM button on the keychain transmitter.

SILENT ARMING - ACTIVE

1. Turn off the engine, exit the vehicle, and close all doors, hood lid, and trunk lid.

2. Press and hold the ARM button on the keychain transmitter for 2 seconds.

sounding device. Where the siren is referenced below, the horn or both may in
fact chirp, or beep.

; The dash mounted LED begins to flash slowly.
; Parking Lights flash two times.
; Siren and or Horn sounds two chirps.

If the siren/horn sounds 4 chirps, then you have left a door, trunk, or hood lid ajar.
Simply close the opened entry point to provide full protection. If the siren "chirped"
four times, sometime after arming, the exclusive delayed dome light learn circuit
has been programmed and the system detected a open entry point after the
learned delay expired. Again, closing the hood, trunk, or doors will correct the
problem and you do not need to disarm the system to make the correction. If the
siren/horn did not sound when arming, then the chirps have been turned off, and
you should refer to the section titled “ ELIMINATING THE ARM / DISARM CHIRPS “
in this manual.

 Doors Lock - Optional

; The dash mounted LED begins to flash slowly.
; Parking Lights flash two times.
; Siren/Horn will not sound.

If the siren "chirped" four times, sometime after arming, the exclusive
delayed dome light learn circuit has been programmed and the system
detected a open entry point after the learned delay expired. Closing the
hood, trunk, or doors will correct the problem and you do not need to
disarm the system to make the correction.

 Doors Lock - Optional

NOTE: Chirps must be selected on to access this feature
ARMING THE SYSTEM - PASSIVE ( AUTOMATIC )

1. Turn off the engine, exit the vehicle, and close and lock all doors, hood lid, and trunk lid.
; The dash mounted LED begins to flash rapidly, indicating 30 second passive

2. Opening any protected entry point during the 30 second passive arming cycle will

arming has begun.

immediately suspend automatic arming and the 30 second passive arming cycle will re­start when all doors are closed. At the end of the passive arming cycle;

; The dash mounted LED begins to flash slowly.
; Parking Lights flash two times.
; Siren and or Horn sounds two chirps.

If the siren did not sound when arming, then the chirps have been turned off, and
you should refer to the section titled “ ELIMINATING THE ARM / DISARM CHIRPS “
in this manual.

 Doors Lock - Optional

Door locking during passive arming is a selectable feature. The alarm can be
programmed to allow the doors to lock only when arming using the keychain
transmitter and they will not automatically lock during passive arming.

Page 2

128-

2 of 8

PROTECTION WHILE THE SYSTEM IS ARMED

; Opening any protected door, hood, or trunk lid will cause the alarm to immediately

sound. The alarm will continue to sound for 30 seconds, then stop and continue to
monitor all protected entry points. If the thief left a door opened, the alarm will sound
for six 30 second cycles, remain armed and ignore that triggered zone.

; Whenever the system is armed, the dash mounted LED indicator will slowly flash.

This serves as a visual deterrent to the potential thief. The LED is a very low current
bulb, and will not cause the vehicle’s battery to drain, even when left unattended for
extended periods.

; Whenever the system is triggered, the vehicle’s parking lights will flash for the full 30

second alarm cycle, attracting visual attention to the vehicle.

; Whenever the system is armed, the vehicle’s starting circuit will be bypassed. If the

thief should choose to ignore the siren/horn, the vehicle can not be started.

; Any strong impact to the vehicle’s glass will cause the alarm to trigger for the full 30

second alarm cycle.

 Any mild impact to the vehicle's glass will cause the alarm to sound a short series of

warning tones.

DISARMING THE SYSTEM
Note: If the optional 2 step door unlock circuit is installed, when the unlock transmitter

button is activated, the drivers door only will unlock, pressing the unlock button a
second time will cause all doors to unlock.

1. As you approach the vehicle, press and release the unlock button on the keychain

transmitter.

; Parking Lights flash one time.

If the parking lights flashed four times, then the alarm was triggered in your
absence. Before turning the key on, examine the LED to identify which zone was
triggered.

; Siren / Horn sounds one chirp.

If the siren/horn sounds 4 chirps, then the alarm was triggered in your absence.
Before turning the key on, examine the LED and refer to the INTRUSION WARN­ING SIGNALS section of this manual to identify which zone was triggered.
If the siren/horn did not sound when disarming, then the chirps have been turned
off, and you should refer to the section titled “ ELIMINA TING THE ARM / DISARM
CHIRPS “ in this manual.

 Doors Unlock - Optional
 2 Step Doors Unlock - Optional
 Entry Illumination Available Option

Note: If the optional entry illumination circuit was added, when the system is disarmed, the

interior light will turn on for 30 seconds, or until the ignition switch is turned on.

WHILE THE SYSTEM IS SOUNDING

If during a triggered state, you wish to shut off the siren without disarming your security
system, simply press and release any transmitter button other than the disarm button. This
action will turn off the siren yet leave the vehicle fully armed and protected. This feature is
particularly useful if you are aware of children playing near your vehicle that may acci­dently trigger your security system. In this case you can cancel the siren sounding without
disarming your alarm.

SILENT DISARMING
Note: If the optional 2 step door unlock circuit is installed, when the unlock transmitter

Page 3

128-

3 of 8