Code Alarm CATX500 User Manual

Model CA TX500

TRANSMITTER PROGRAMMING

1) Enter the vehicle, and turn the ignition switch to the ON position.

2) Press and release the Programming button switch 3 times.

3) Press and hold the LOCK button of the transmitter you wish to program.

4) The lights will flash 1 time, indicating that the system is accepting the
programming of channel #1 which is lock.

"Repeat step 3 for each transmitter you wish to program"

5) Press and release the valet push button switch 1 time to advance to
channel 2.

6) Press and hold the UNLOCK button of the transmitter you wish to
program.

7) The lights will flash 1 time, indicating that the system is accepting the
programming of channel #2 which is unlock.

"Repeat step 6 for each transmitter you wish to program"

8) Press and release the valet push button switch 1 time to advance to
channel 3.

9) Press and hold the TRUNK button of the transmitter you wish to
program.

10) The lights will flash 1 time, indicating that the system is accepting the
programming of channel #3 which is trunk.

"Repeat step 9 for each transmitter you wish to program"

11) Press and release the valet push button switch 1 time to advance to
channel 4.

12) Press and hold the STAR button of the transmitter you wish to program.

13) The lights will flash 1 time, indicating that the system is accepting the
programming of channel #4 which is remote start.

"Repeat step 12 for each transmitter you wish to program"

Technical Support [phone]

http://techservices.codesystems.com

or go to