Code Alarm CA-630 User Manual

Remote Vehicle Control System

CA-630

Owner's Manual

Car Start, Security and

Convenience System

IMPORTANT N OTE: The operation of the IV-F65 as described in this manual is applicable

to most vehicles. However, due to the engine type and configuration of some vehicles (i.e.

diesel engines), some functions AND/OR SAFETY PRECAUTIONS may not apply . Please

see your installing dealer for more information.

Table of Contents

Features and Benefits of the CODE ALARM CA-630............... 3

Note: Any feature or function noted with “optional” requires additional installation labor, components and installation cost. See your dealer for details.

Using the Security features................................................... 4/5

Arming the Security System

Pre-arm Mode

Disarming the Security System

Attempted Intrusion Identification

Two-Stage Door Unlock Activating the Trunk Release Feature Using the Car Finder Feature Personal Protection Alarm (Panic) Remote Start / Stop Feature

How your Shock Sensor works

Disabling the IT-s

Using Valet Mode ....................................................................... 6

Using Y our Remote Starter ...................................................... 7

Starting Your Vehicle

If your vehicle stalls or does not start

Remote Start Safety Features Entering the Vehicle While it is Running via Remote Start Pre-Heating or Pre-Cooling the Interior of the Vehicle Using the “Quick-stop” Feature

Interior Theft Sensor

Automatic Convenience Options ............................................ 8

When Your Security System is Triggered ............................... 8

The Interior Status Indicator .................................................... 8

System Maintenance ................................................................ 9

Changing the Remote Control Battery Adding Remote Controls to Your System Deleting Lost or Stolen Remote Controls from Your System

Basic Troubleshooting ............................................................ 10

Emergency Disarm Procedure .......................................... 11

Emergency Disarm Button Location

Code Alarm WarrantyPlan ..................................................... 12

Code Alarm Theft Protection Plan ......................................... 13

Features and Benefits of the Code Alarm CA-630

Two Easy-to-Use Weather-Resistant Remote Controls

The remote controls included with the Code Alarm CA-630 utilize durable, moisture resistant cases and sealed rubber buttons for reliability and long life. Rolling code technology prevents the transmitter signals from being duplicated. The button functions are clearly labeled to make the CA-630 simple to operate.

All Entrances Protected

Opening any door or entrance protected by the security system triggers the vehicle’s horn and flashes the vehicle parking lights.

Starter Disable

The Code Alarm CA-630 protects your vehicle from theft by disabling the starter when the system is armed.

IT-s

Interior Theft Sensor

This patented sensor uses infra-red technology to reliably detect vehicle impact associated with attempted intrusion. The IT-s sensor guards against vehicle body damage, and theft of the vehicle’s equipment (such as airbags) and personal belongings.

Remote Keyless Entry

The Code Alarm CA-630 conveniently locks and unlocks vehicle doors and opens the trunk or hatch by remote control.*

Personal Protection Features

Remote Panic Alarm, Illuminated Entry, and Car Finder are among an array of features that enhance personal safety.**

Interior Status Indicator

The bright-blue warning light is an effective visual deterrent to a would-be thief.

Remote Start

The Code Alarm CA-630 allows you to warm up your vehicle and preheat or pre-cool the interior with the press of a button on the remote control.

PowerRange

Antenna

This long-range antenna allows you to operate the Code Alarm CA630 from distances of up to 1/8 mile. Remote-start your vehicle from the safety of your home, apartment or office building.

* If vehicle is equipped with power door locks and they are connected to the alarm system by your installer.

** May require additional connections, components, and/or charges. See your installer for details.

Using the Security and Keyless Entry features

UNLOCK Button

Press to Disarm Security

System and Unlock

LOCK Button

Press to Arm Security

System and Lock

Doors

Press Twice for Two-

Stage Door Unlock*

Press and Hold to Open

Doors

Trunk

FIND/PANIC Button

Press for Car Finder

Press and Hold for

Panic Alarm

START Button

Press and Hold for

Remote Start / Stop

Press to Activate

Rear Defroster

Arming the Security System

To arm the system, exit the vehicle, close all doors, then press* the LOCK button. The horn will “chirp” twice flash twice, indicating the system is armed. The doors will also lock at this time (if equipped and connected). The status indicator (blue warning light on the dash) will blink steadily, once per second.

Pre-arm Mode

If the horn chirps and the parking lights flash only once, this indicates that the vehicle courtesy light is on, or that an entrance is not closed securely. Check to see that doors, hood, and trunk are properly closed. Once all entrances are secured (and the courtesy light is off), the system will chirp / flash again. The system is now fully armed. (If the entrance is not secured within 4 minutes, the system will arm and ignore the unsecured entrance until it is closed.)

Disarming the Security System

To disarm the system, press the UNLOCK button. The horn will chirp and the parking lights will flash once, and the doors will unlock (if equipped and connected). The courtesy light will turn on for 1 minute, or until the vehicle is started.

†

and the parking lights will

Two-Stage Door Unlock (optional)

If this feature is enabled on your system, pressing UNLOCK one time will unlock only the driver’s door. Press UNLOCK again within 1 minute to unlock all doors.

* Throughout this manual, ‘press’ refers to pressing or less than 1 second; ‘press and hold’ refers to

pressing for more than 1 second.

†

If you have chosen the Silent Arming Option, the horn will not sound when arming or disarming until the appropriate button is pressed a second time.

Using the Security and Keyless Entry features (cont.)

Activating Trunk Release Feature

(vehicle must have power trunk/hatch)

Press and hold the UNLOCK button for 2 seconds to open the vehicle trunk or hatch.

Using the Progressive Car Finder Feature

Press the FIND/PANIC button on the remote control to locate your vehicle. The horn will emit five short chirps at low volume, increasing in volume each of three times the button is pressed.

Personal Protection Alarm (Panic)

Press and hold the FIND/PANIC button to activate the vehicle horn and parking lights for 30 seconds. (If the vehicle horn is connected, the horn will “pulse” for 30 seconds.) Press any remote control button to turn off the “Personal Protection Alarm”.

How your IT-sTM Interior Theft Sensor Protects Your V ehicle

Your sensor is designed to respond to impact to critical vehicle surfaces. It is a dual stage sensor. A light, non-damaging impact will cause the vehicle horns to emit a short “chirp”. A harder, damaging impact will cause the vehicle horn to emit a continuous honking sequence.

Disabling the IT-sTM Interior Theft Sensor

It may be necessary at times to disable the IT-sTM Interior Theft Sensor, especially when parking in areas (like parking garages) where extreme vibration may cause false alarms. Press the LOCK button and then press the FIND/PANIC button within two seconds of pressing LOCK to disable the interior theft sensor. The horn will chirp two times to indicate that the sensor is disabled. The sensor will become enabled again the next time the system is armed normally.

Attempted Intrusion Identification

In the event that the security system was triggered in your absence the blue dash mounted LED will be rapidly flashing and upon disarming/unlocking the vehicle the siren/horn will chirp 4 times. To determin which zone triggered the system enter the vehicle and press and release the valet button one time, the siren/horn will chirp as listed below to indicate the triggered zone. NOTE: DO NOT turn on the vehicles ignition, doing so resets the intrusion ID.

SHOCK 1 Chirp

DOOR 2 Chirps

HOOD 3 Chirps

IGNITION 5 Chirps

+ 9 hidden pages