Code Alarm CA611 User Manual

CA611 Owners Manual

CAUTION!

Be certain that the vehicle is outdoors before using this or any re­mote vehicle starting device. A running engine produces dangerous
carbon monoxide fumes which can be harmful or fatal if prolonged
exposure occurs. DO NOT remote start the vehicle if the car is
garaged.

Your Remote Start Alarm System has many features and available options
some of which are selected at time of installation. Consult your installing
dealer for options that may have been installed and are not listed.

ARMING THE SYSTEM:

1. Turn the engine OFF, exit the vehicle, and close all doors, hood and trunk.

2. Press and release the Arm button of your transmitter one time.
The parking lights will flash once, the siren will chirp once, and the LED will

begin to flash slowly confirming the system is armed. If you have the optional
door lock/unlock circuit installed, the doors will lock.

NOTE: If the siren/horn sounds 3 chirps, then you have left a door, trunk, or
hood ajar. Simply close the opened entry point to provide full protection. If the
siren "chirped" 3 times, sometime after arming, the exclusive delayed dome
light learn circuit has been programmed and the system detected a open
entry point after the learned delay expired. Again, closing the hood, trunk, or
doors will correct the problem and you do not need to disarm the system to
make the correction. If the siren/horn did not sound when arming, then the
chirps have been turned off and you should refer to the section titled
"ELIMINA TING THE NORMAL ARM/DISARM CHIRPS" (page 9) of this manual.

SILENT ARMING:

1. Turn the engine OFF, exit the vehicle, and close all doors, hood and trunk.

2. Press and hold the Arm button of your transmitter for 2 seconds.
The parking lights will flash once, and the LED will begin to flash slowly

confirming the system is armed. The siren will not chirp. If you have the
optional door lock/unlock circuit installed, the doors will lock.

NOTE: If the siren/horn sounds 3 chirps, then you have left a door, trunk, or
hood ajar. Simply close the opened entry point to provide full protection. If the
siren "chirped" three times, sometime after arming, the exclusive delayed
dome light learn circuit has been programmed and the system detected a
open entry point after the learned delay expired. Again, closing the hood,
trunk, or doors will correct the problem and you do not need to disarm the
system to make the correction. If the siren/horn did not sound when arming,
then the chirps have been turned off and you should refer to the section titled
"ELIMINATING THE NORMAL ARM/DISARM CHIRPS" (page 9) of this manual.

Page 2

ARMING THE SYSTEM:

If the passive arming feature has been selected:
Turn the engine OFF, exit the vehicle, and close all doors, hood and trunk.
The LED will begin to flash rapidly indicating that the 30 second passive

arming timer has begun. If the dash mounted LED does not begin to flash
rapidly, then you have left a door, hood, or trunk ajar. Closing this entry point
will allow the arming cycle will begin. If any entry point is opened during the
30 second arming cycle, arming will be suspended. When all entry points are
closed, the arming cycle will begin again.

At the end of the 30 seconds, the parking lights will flash once, the siren will
chirp once, and the LED will begin to flash slowly confirming the system is
armed. If the siren/horn did not sound when arming, then the chirps have
been turned off. Refer to the section on "Eliminating the normal Arm/Disarm
Chirps" found on page 8 of this manual. Passive door locking is a selectable
feature. If you have the optional door lock/unlock circuit installed, the doors
may or may not lock passively depending upon the setup during installation.

PROTECTION WHILE THE SYSTEM IS ARMED:

Opening any protected entry point, hood, trunk, or doors will cause the alarm
to trigger immediately. The siren/horn will sound and the parking lights will
flash for 30 seconds, then stop and continue to monitor all protected entry
points. If the thief left the door opened, the system will sound for six 30
second cycles then shut down, isolate the triggered zone and continue to
protect all other zones.

Whenever the system is armed, the LED will slowly flash. This serves as a
visual deterrent to a potential thief. The LED is a very low current light emitting
diode (L.E.D.), and will not cause the battery to drain even if left unattended for
long periods of time.

Whenever the system is triggered, the vehicle's parking lights will flash for the
full siren/horn sounding period.

Whenever the system is armed, the vehicle starter circuit is disabled, and the
vehicle will not start with the ignition key.

Whenever the system is armed, any strong impact to the vehicle will cause
the shock sensor to trigger the alarm. Any lesser impact will cause the pre­detect stage of the shock sensor to emit a few short series of warning tones
from the siren/horn.

Page 3

DISARMING THE SYSTEM:

As you approach the vehicle, press and release the Disarm button on the
transmitter. The parking lights will flash 2 times, the siren/horn will chirp 2
times, and the LED will turn off.

If you have the optional door lock/unlock circuit installed, the doors will unlock.
If you have the optional entry illumination circuit installed, the interior light will
turn on for 30 seconds or until the ignition key is switched on.

NOTE: If the passive arming mode was selected at time of installation, the
LED will start flashing rapidly indicating that the system is rearming. Opening
any door will suspend the automatic arming.

If the parking lights flashed 3 times, and the siren/horn chirps 4 times, this
indicates that the alarm system was triggered during your absence. Before
turning on the ignition key, examine the LED flash pattern. The number of
flashes identifies the triggered zone. For additional information, refer to
INTRUSION WARNING SIGNALS (page 5) of this manual.

If the siren/horn did not sound upon disarm, then the chirps have been turned
off. Refer to the section titled ELIMINA TING THE NORMAL ARM/DISARM
CHIRPS (page 8).

NOTE: If the optional 2 step door unlock circuit is installed, when the unlock
transmitter button is activated, the driver's door only will unlock, pressing the
unlock button a second time will cause all doors to unlock.

SILENT DISARMING:

1. As you approach the vehicle, press and hold the disarm button of your
transmitter for 2 seconds.

The parking lights will flash 2 times, and the LED will turn off confirming that
the system is disarmed. The siren/horn will not chirp. If you have the optional
door lock/unlock circuit installed, the doors will unlock. If you have the optional
entry illumination circuit installed, the interior light will turn on for 30 seconds
or until the ignition key is switched on.

NOTE: If the passive arming mode was selected at time of installation, the
LED will start flashing rapidly indicating that the system is rearming. Opening
any door will suspend the automatic arming. If the parking lights flashed 3
times, and the siren/horn chirps 4 times, this indicates that the alarm system
had been triggered in your absence. Before turning on the ignition key,
examine the LED flash pattern. The number of flashes identifies the triggered

Page 4