Code Alarm CA 5051MT User Manual

PROFESSIONAL
SERIES
Owner ’s Guide
Manual Transmission Remote
Start and Keyless Entry System
IMPORTANT NOTE: The operation of the Security and Convenience System as described in this manual is
applicable to most vehicles. However, due to the configuration of some vehicles, some functions AND/OR
SAFETY PRECAUTIONS may not apply . Please see your installing dealer for more information.
12010 Audiovox Electronics Corporation. All rights reserved.
Table of Contents
Using Your Remote Control ...............................................................3
Using the Keyless Entry ................................................................... 3
Two Stage Door Unlock (optional) ...................................................3
Activating Trunk Release (optional) ................................................3
Using the Progressive Car Finder Feature......................................3
Using the Personal Protection Alarm ............................................... 3
Programmed Transmitter Notification ..............................................3
Valet Mode ........................................................................................4
Eliminating Lock / Unlock Notification Chirps ................................... 4
Using Your Remote Control ...............................................................4
Remote Start Ready Mode................................................................4
Cancelling Remote Start Ready Mode .............................................5
Remote Starting Your Vehicle .......................................................... 5
Remote Start Shutdown ................................................................... 5
Entering Your Vehicle while it is Running via Remote Start ...........5
Preheating or Precooling the Vehicle’s Interior...............................5
User Programmable Run Time / Run Time Extension ...................... 6
Remote Start Safety Features .........................................................6
Transmitter Button Functions ...........................................................6
Replacing Remote Control Batteries ...............................................7
Warranty Information ...........................................................................8
2 2010 Audiovox Electronics Corporation. All rights reserved.
Using Your Remote Control
Using the Keyless Entry
The button is used to lock the vehicle's doors, the button is used to unlock the vehicle's doors. To lock or unlock the doors simply press and release the desired function button one time. For your convenience, the parking lights will flash once when the doors are unlocked and twice when the door are locked.
NOTE: The system is defaulted with Silent Choice enabled, which requires a second press of the or button to activate an audible locking/unlocking response from the vehicle. If your system is set up for 2 step unlock, a third press of unlock will activate the audible response.
Two Stage Door Unlock (Optional)
If this feature is enabled on your system, pressing the button one time will unlock only the driver’s door. Press again within three seconds to unlock the remaining doors.
Activating the Trunk Release Feature (Optional)
The button is used to open the trunk of the vehicle. To open the vehicle's trunk press and hold the button for 3 seconds.
Using the Progressive Car Finder Feature
Press the button to locate your vehicle. The system will sound 5 times at low volume, increasing in volume each time the button is pressed.
Using the Personal Protection Alarm (Panic)
Press and hold the button for 3 seconds to activate the personal protection alarm. During panic mode, the normal function of the transmitter buttons will be suspended. The transmitter’s and buttons can be used to lock and unlock the
door (if the option is installed). To stop the alarm, press and hold the button on the transmitter again for 3 seconds. The system will automatically stop after 30 seconds.
Programmed Transmitter Notification
As a security precaution each time the vehicle’s ignition is turn on the status LED light with flash the number of transmitters programmed into the system. This helps to identify unauthorized transmitters from accessing your vehicle. If you believe an unauthorized transmitter has been programmed to your system, contact your installing dealer for assistance.
32010 Audiovox Electronics Corporation. All rights reserved.
Loading...
+ 7 hidden pages