COBY IR850 User Manual

Requirements

2
3

1

7

6

4
5

Quick Start Guide

IR850 | Wireless Internet Radio

To connect and use your Internet Radio, you will need the following:

Broadband Internet connection •

A connection speed of 64 Kbps or greater is recommended.

Wireless Router or Access Point•

Your wireless router should support Wi-Fi 802.11b/g connections.
If you have a router that supports 802.11n, make sure that it has

been congured to accept 802.11b/g connections as well.

Wireless Router Network Settings•

You will need to know the name of your network (SSID) as well as
the WEP or WPA password if your network is secured. These set­ings can usually be found on the administration webpage of your
wireless router. Please refer to your wireless router’s documenta­tion for help.

Basic Controls

Remote Key Function

1

2

3

4

Navigate through menus (Left,
Right, Up, Down)

Enter a menu selection.

Access the Main menu

Change the station information
displayed on screen.

Change the function mode
(Internet Radio, Music Player,
FM radio)

Remote Key Function

7

For a full description of all available controls,
please refer to the instruction manual.

Before using the remote control, pull out

the protective strip of plastic from the bat­tery compartment to remove it.

Turn the volume level down.

5

6

Turn the unit on or off

Turn the volume level up.

Connect to Your Wireless Network

You will need to congure the IR850 to connect to the internet through
your wireless network the rst time you use it. After that, the IR850 will

automatically connect to the internet using these saved settings un­less you reset the unit to its factory-default settings.

Connect the Power. 1)

Plug one end of the power adapter into the Power jack located
on the bottom of the unit, then plug the other end into an AC 100­240V wall outlet. Press

Switch to Internet Radio mode.2)
When the unit turns on, the Main menu will be displayed. Press
press

Select Your Region.3)
Press

to conrm. The network wizard will launch.

repeatedly until the display reads [Internet radio].

or to choose your region from the menu and then press

to turn the radio on.

If the name of your network does not appear in the list, select b)

[Rescan] to have the unit try to nd your network again.

If you still cannot nd your network, your router may be con-c)
gured to hide your SSID name. In this case, you will need to
enter your network settings manually. Choose [Manual cong]

from the menu and press

Enter the WEP/WPA Password (if necessary). 5)

If security is enabled, you will be asked to input the WEP or WPA
password. A password entry screen will display as follows:

Use the direction keypad (• ) to navigate the alphanu-
meric character list. Press

If you make a mistake while entering your password, select the •
‘BKSP ’ icon to delete the previous character.

to conrm.

to input a character.

Select Your Network (SSID).4)
The unit will scan the area and display all available networks. The
name of your network is determined by the SSID setting of your
wireless access point.

Press a)
menu list and then press

does not have WEP or WPA security enabled, the unit will nish

connecting to the network and return to the Internet Radio menu.

or to choose the name of your network from the

to conrm. If your network

Select the ‘OK’ icon when you have nished entering your pass-•
word. The unit will nish connecting to the network and return to

the Internet Radio menu.

 Forhelpwithadvancedwirelessroutercongurations,pleaserefer

to the router’s documentation. The MAC address of the unit can be
found in the System Settings menu (Main Menu > System settings
> Network > View settings > MAC Address).