Cobra Electronics MT 200 User Manual

LLCCDD DDiissppllaayy
SSppeeaakkeerr// MMiiccrroopphhoonnee// CChhaarrggee JJaacckk
CCaallll BBuuttttoonn
TTaallkk BBuuttttoonn
Release the Tal k button when you are finished talking and listen for a response. You cannot receive incoming calls while pressing the
Tal k button.
NOTE Both radios must be
tuned to the same channel to communicate.
Press and release to alert others that you are calling.
TWO-WAY RADIO MODEL
MT 200
Nothing Comes Close to a Cobra
®
English
RRaaddiioo CCoonnttrroollss aanndd IInnddiiccaattoorrss
Printed in the Philippines
Part No. 480-255-P
Version A
MMooddee//PPoowweerr BBuuttttoonn
UUpp//DDoowwnn BBuuttttoonnss
Press and hold to turn the radio on or off.
Press and release to enter mode function to change channels.
The channel numbers will blink when that mode is selected. Use the Up/Down buttons to select a channel.
Press and release to adjust the volume.
While in mode function, press and release to change channels.
9498 MT200-EU-British4F 4/10/06 2:38 PM Page 1
WWaallll CChhaarrggeerr
BBaatttteerriieess aanndd WWaallll CChhaarrggeerr
BBaatttteerryy CCoommppaarrttmmeenntt CCoovveerr
AAnntteennnnaa
BBeelltt CClliipp
WWaallll CChhaarrggeerr
BBaatttteerriieess
TToo iinnssttaallll oorr rreeppllaaccee bbaatttteerriieess::
1. Remove belt clip by releasing belt
clip latch and sliding clip up.
2. Pull up on the battery door latch to
remove the battery compartment cover.
3. Insert the supplied three AAA
rechargeable batteries (also works with non-rechargeable
alkaline bat­teries). Position batteries according to polarity markings.
4. Replace battery compartment cover
and belt clip.
IInnsseerrtt BBaatttteerriieess
PPuullll LLaattcchh UUpp
RReemmoovvee BBeelltt CClliipp
RRaaddiioo CChhaarrggeerr JJaacckk
22
EEnngglliisshh
TToo cchhaarrggee bbaatttteerriieess iinn rraaddiioo::
1. Check to see that the batteries
have been inserted properly. See above for battery installation instructions.
2. Insert round connector of wall charger into the charge jack
located at the top of the radio. The wall charger has two round connectors which enables you to charge either one or two radios at a time.
3. Plug the wall charger into electrical outlet. It normally takes 15 hours to fully recharge batteries. It is not
recommended to recharge batteries more than 24 hours. Estimated operation time on a full charge is 8 hours.
Use only the supplied rechargeable batteries and wall charger for recharging your Cobra microTALK
®
radio. Non-rechargeable
alkaline batteries can also be used.
9498 MT200-EU-British4F 4/10/06 2:38 PM Page 2
BBaacckklliitt LLCCDD DDiissppllaayy
33
EEnngglliisshh
BBaatttteerryy LLooww IIccoonn
Blinks when battery power level is low.
Your microTALK®radio has a unique circuit designed to extend battery life. If there are no transmissions within 10 seconds, the radio will automatically switch to Battery Save mode. This will not affect the radio’s ability to receive incoming transmissions.
CChhaannnneell NNuummbbeerr
While in Standby mode or when selecting a channel, shows current channel (1 through 8).
When adjusting the volume, shows current level (1 through 8).
CChhaannnneell//VVoolluummee IInnddiiccaattoorr
“CH” is visible when in Standby mode or when
selecting a channel.
“LE” is visible when adjusting volume.
TTrraannssmmiitt IIccoonn
RReecceeiivvee IIccoonn
Visible when transmitting a message.
Visible when receiving a message.
9498 MT200-EU-British4F 4/10/06 2:38 PM Page 3
Declaration of Conformity
This declaration is the responsibility of the manufacturer/importer
Cobra Electronics Europe Limited Dungar House Northumberland Avenue Dun Laoghaire
County Dublin, Ireland Date: 21 November 2005 This certifies that the following designated product
PRIVATE MOBILE RADIO: MT 200
complies with the essential protection requirements of R & TTE Directive 1999/5/EC on the approximation of the laws of the Member States relating to Radio Spectrum Matters, EMC and Electrical Safety.
This declaration applies to all specimens manufactured in accordance with the attached technical documentation described in Annex II of the Directive which forms part of this declaration.
Assessment of compliance of the product (class 2.6) with the requirements relating to the essential requirements according to Article 3 R & TTE was based on Annex IV of Directive 1999/5/EC and the following standards:
Radio Spectrum: EN 300 296-1 V1.1.1 (2001-03)
EN 300 296-2 V1.1.1 (2001-03)
EMC: EN 301 489-1 V1.4.1 (2002-08)
EN 301 489-5 V1.3.1 (2002-08)
Electrical Safety: IEC 60950-1:2001 /
EN 60950-1:2001
RF Exposure: EN 50392 (2004-02)
DUBLIN, IRELAND MIKE KAVANAGH
0682
For use in EU countries, subject to local laws and regulations.
CEEL™ is a trademark of Cobra Electronics Corporation, USA.
Snake design and microTALK
®
are registered
trademarks of Cobra Electronics Corporation, USA. ©2006 Cobra
®
Electronics Europe Limited Dungar House, Northumberland Avenue Dun Laoghaire, County Dublin, Ireland
www.cobra.com
DD..OO..CC.. ,, WWaarrrraannttyy aanndd CCuussttoommeerr SSeerrvviiccee
Warranty & Customer Service
For warranty and customer service information, please contact your local dealer.
44
EEnngglliisshh
9498 MT200-EU-British4F 4/10/06 2:38 PM Page 4
Loading...