COATS Kit 85607817 User Manual

85607817 Service Kit

For use with COATS 85607503
Quick Release Hub Nut

Hennessy Industries • 1601 J. P. Hennessy Drive, LaVergne, TN USA 37086-3565 [phone] • [phone] • [phone] FAX • www.ammcoats.com

Parts Identification

2

3

6

Item Description

1 0.7 x 12mm FHCS SCREW, M4
2 CAP
3 SPRING
4 ACTUATOR
5 THREADED INSERT
6 HUB NUT

1

4

5

Tools Needed:

2.5 mm Hex Key
Needle Nose Pliers
Grease
Loctite® 242 Threadlocker

Instructions

1. Use a 2.5 mm hex key and remove the four screws

that fasten the CAP to the HUB NUT.

2. Disassemble the two SPRINGS, ACTUATOR, and

two THREADED INSERTS from the HUB NUT.

3. Now using the new kit parts, assemble the two
THREADED INSERTS, ACTUATOR, and two SPRINGS
to the HUB NUT. Note that the long end of the SPRING
goes into the HUB NUT and the short end goes into the
ACTUATOR. Grease the ACTUATOR and THREADED
INSERTS.

4. Fasten the CAP to the HUB NUT using the sup­plied screws. Add some Loctite 242 threadlocker to the
fasteners.

Loctite® is a registered trademark of Henkel Corporation

85607862 00 06/12 1 of 1 © Copyright 2012 Hennessy Industries and COATS All Rights Reserved