COATS Kit 85000440 User Manual
1601 J. P. Hennessy Drive, LaVergne, TN USA 37086 615/641-7533 800/688-6359 Manual Part No.: 85000439 02
HENNESSY INDUSTRIES INC. Manufacturer of AMMCO
®
, COATS®and BADA®Automotive Service Equipment and Tools. Revision: 5/07
Wheel Lift Kit 85000440
For use with COATS Models 50xx, 60xx, 70xx, or
APX Series Tire Changers
®
User Instructions
with Parts Identification
READ these instructions before placing unit in
service KEEP these and other materials delivered
with the unit in a binder near the machine for
ease of reference by supervisors and operators.
This is a supplement to your operating manual and covers the installation and use of the COATS
®
Wheel LIft. If you do not have your original operating manual, please call COATS at 1-800-688-6359
to request an additional copy.
Wheel Lift Installation
Always DISCONNECT THE ELECTRICAL
POWER before servicing equipment. This
prevents electrical shock or accidental
movement of the systems operated by the
electrical power.
Always DISCONNECT AIR SUPPLY before
servicing equipment. This prevents accidental movement of systems operated by compressed air which may result in personal
injury. BLEED THE AIR SYSTEM by actuating
all the valves.
STAY CLEAR OF MOVING PARTS when
reconnecting the unit to the air supply. The
position of control valves may have
changed during the servicing of the
machine.
50xx, 60xx, 70xx Series Instructions
1. Disconnect the electric and air power supplies to
the machine and wait for the air pressure to deplete.
2. Disconnect the supply air line from the bottom of
the lift control valve.
3. If applicable, remove lube bottle and bracket
located on the chassis side panel. Set lube bottle aside.
4. If applicable, install new lube bracket on tire
changer tower using the supplied 6-inch hose clamp.
Be sure to position hose clamp and bracket were it
does not cover any important safety information on the
large safety decal. Place lube bottle into bracket.
CAUTION
CAUTION
CAUTION
2 • COATS Wheel Lift Kit
5. Remove three bolts from transmission as shown
above. Reserve bolts for later use.
6. Place lift mounting bracket on chassis and align on
the three holes.
7. Install lift mounting bracket to chassis using the
three reserved transmission bolts.
Important: Torque bolts at 30 foot pounds.
8. Install tire lift on tire changer using six fasteners
(three on each side into lift bracket/chassis).
9. Attach pedal guard to the lift, as shown above.
10. Disconnect output air line from filter lubricator
assembly. Now run air line from wheel lift to back of
tire changer. Attach wheel lift airline with tee fitting into
output side of filter lube unit as shown. Reattach output air line at tee fitting.
Note: If necessary, use Teflon™ tape or equivalent on
threaded fittings.
11. Functional test the wheel lift.
Replace
Three Bolts
Attach Foot
Pedal Brow
Wheel Lift Airline Into
Output Side Filter Lube
Reattach
Output
Airline
At Tee
Remove
Three Bolts
COATS Wheel Lift Kit • 3
Loading...