COATS Kit 814422 User Manual

8114423 00 11/05 © COPYRIGHT 2005 ALL RIGHTS RESERVED PRINTED IN U.S.A.

Instructions:

1. Hold bracket up to the edge of the hood cam

plate and mark the two holes on the plate to drill.

2. Use a punch to mark the center of the holes.

3. Drill out two holes using a 5/16-inch bit. Note

that it may be easier to first drill out a small pilot
hole.

4. Install bracket with the supplied button head

screws and nuts.

5. Ensure proper activation of hood after installa­tion by lowering the hood to make sure the mecha­nism activates the tire rotation.

6. If the rubber stop is completely worn out,
replace rubber stop with the one supplied in the kit.

HHoooodd SSttoopp RReettrroo

KKiitt 88111144442222

ffoorr XXRR SSeerriieess WWhheeeell BBaallaanncceerrss

COATS, Inc. • Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086-3565

[phone] • [phone] • [phone] FAX • www.ammcoats.com