COATS Kit 8114160 User Manual
8114160 00 12/04 © COPYRIGHT 2004 HENNESSY INDUSTRIES AND COATS ALL RIGHTS RESERVED PRINTED IN U.S.A.
For XR Series Balancers Only
Kit 8114160
COATS, Inc. • Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086-3565
(800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX • www.ammcoats.com
Instructions
Important: If the decal being replaced is an older/different decal than the new decal shown above, then the
ON/OFF switch must be rotated 180-degrees to match
the new decal ON/OFF graphic.
1. Turn power OFF at machine.
2. Unplug power cord at receptacle.
3. Remove weight tray.
4. Press retaining tabs at top and bottom of switch
and push switch outward through panel hole.
5. Rotate switch 180-degrees and press back into
the same hole.
6. Assemble parts back in reverse order, add the
new decal and power up machine.
New ON/OFF Graphic
Loading...