COATS Kit 8113893 User Manual

8113894 01 06/04 © COPYRIGHT 2004 HENNESSY INDUSTRIES AND COATS ALL RIGHTS RESERVED PRINTED IN U.S.A.

Lateral Runout Service

Kit 8113893

COATS, Inc. • Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086-3565

[phone] • [phone] • [phone] FAX • www.ammcoats.com

Parts Identification

Ref Qty. Description

1 1 Lateral Runout Assembly

(with Cable and Sonar)
2 1 Lateral Runout Guard
* 2 1/4-20 x 1-1/4" HHCS
* 2 1/4-20 Hex Nylok Nut
3 1 Lateral Runout Decal
4 1 11/16 Rubber Grommet
* 1 1/4-20 x 1" Self Tap Screw
5 1 Danger Laser Decal
6 1 Laser Conformance Decal
7 1 Laser Aperture Decal

*Not Shown

Instructions

1. Unplug connector 12 at power PCB.

2. Remove angle bracket and connector from flange

of sandplate inside front of cabinet.

3. Remove screws and nuts holding lateral runout
mounting rail and guard to cabinet and remove lateral
runout assembly from machine.

4. Install new Lateral Runout Assembly and Guard on
cabinet at same location as the old one and fasten with
1/4-20 x 1-1/4" HHCS and 1/4-20 Hex Nylok Nuts.

5. Mount angle bracket with connector on the inside
of cabinet in the same position as before.

6. Connect one end of the audio cable to this con­nector and the other end to connector 12 at power PCB.

Angle

Bracket &

Connector

Lateral Runout
Cable Entering

Cabinet

Runout Guard

Lateral Runout

Assembly

Screw

Location

Screw

Location

3

6

4

7

5

2

1

1