COATS Kit 8113883 User Manual

PPrriinntteerr BBrraacckkeett

SSeerrvviiccee KKiitt 88111133888833

COATS, Inc. • Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086-3565

(800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX • www.ammcoats.com

Parts Identiﬁcation

Ref. Qty. Description

1 1 Rubber Grommet 2 2 Hex Washer Head Screw 3 1 Printer Bracket 4 1 Loop Fabric *Velcro®Strip 5 1 Printer Instructions Decal 6 1 Caterpillar Grommet

7 2 Nylon Cable Tie

Instructions

1. Lift printer and unplug RJ11 connector on bottom

of printer. Set printer aside for reuse.

2. Untie wiring at back of bracket.

3. Remove two screws holding bracket to side of

monitor tower. Discard old bracket. Install new round Rubber Grommet on monitor tower, if required.

4. Install new Printer Bracket to monitor tower using two self-tapping Hex Washer Head Screws in the same holes used by the old bracket.

5. Install black Caterpillar Grommet in oval shaped hole at back of Printer Bracket and tie printer cable through hole as before.

6. Apply adhesive-backed *Velcro

Strip abut 1-inch from left edge of Printer Bracket and 1 to 1/2-inch from front of bracket.

7. Insert RJ11 connector in bottom of printer and

place printer on Velcro as before.

8. Apply Printer Instruction Decal centered on front of

bracket.

RJ11 Connector Plug

Printer Instruction Decal Location

* Velcro®is a registered trademark of Velcro Industries B.V.