COATS Kit 8113881 User Manual

PPrriinntteerr SSeerrvviiccee

KKiitt 88111133888811

COATS, Inc. • Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086-3565

(800) 688-6359 • (615) 641-7533 • (615) 641-5104 FAX • www.ammcoats.com

Parts Identiﬁcation

Ref. Qty. Description

1 1 Printer 2 3 Hook Type *Velcro

3 1 Loop Fabric *Velcro®Strip

4 2 Nylon Cable Tie

Instructions

1. Turn OFF power at machine.

2. Apply the adhesive-backed Velcro as follows:

a.) Apply two pieces of the Hook Type Velcro to bottom front and back low point of the printer case between the foot bumpers.

b.) Apply the strip of Loop Fabric Velcro to the lower receptacle face of the duplex receptacle inside of the cabinet.

c.) Apply one piece of the Hook Type Velcro to the printer adapter on the prong side of the adapter at opposite end.

3. Untie wiring at printer bracket, unplug RJ11 con-

nector on bottom of printer, and remove printer.

4. Remove old adapter at duplex receptacle inside machine and plug in new adapter. Make sure the Velcro strips match.

5. Place “Printer to Serial” connector in wiring tray and plug into serial connector from main PCB, route RJ11 connector cable through cable hole in back of cabinet to printer. (Tie wiring at back of printer bracket.) Attach adapter to printer connector to serial connector in wiring tray. Lay excess cable in bottom of wiring tray and tie as necessary.

6. Install roll of thermal paper in printer, plug RJ11 connector into bottom of printer, and place printer on Velcro at printer bracket.

Important: Software

will not recognize printer connected unless paper is installed and installed correctly. Install as shown above and close cover.

* Velcro®is a registered trademark of Velcro Industries B.V.

Serial

Connector

in Wiring

Tray

Cable

Hole

Loop Fabric

Velcro

RJ11 Connector Plug

Remove

“Old Printer

To Serial”

Connector

Install Roll of Thermal Paper

Hook Type

Velcro

Hook Type

Velcro