COATS Kit 8113082 User Manual

8113084 00 05/01 © COPYRIGHT 2001 HENNESSY INDUSTRIES AND COATS ALL RIGHTS RESERVED PRINTED IN U.S.A.

COATS, Inc. • Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086-3565

[phone] • [phone] • [phone] FAX • www.ammcoats.com

40mm Conversion Shaft

Kit 8113082

For use with 950, 1025, 1050, & 1055 Model Series Balancer

Installation

1. Turn off and unplug the Balancer.

2. Prevent the faceplate from rotating and use an appropriate size

wrench to remove the existing stub-shaft. (Fig. 1)

3. R emo ve the back spring retainer, if in place at the base of the motor

shaft.

4. Using a penetrating oil, carefully clean the motor shaft. (Fig. 2)

5. Install the coupler using a 5/16" hex wrench and tighten to 60 to 80

ft-lbs. (Fig. 3 & 4))

6. Remove the 40mm shaft from it’s protective sleeve.

7. Make sure the inner bore diameter is free of any debris.

8. Install the 40mm shaf t onto the motor shaft. Rotate the motor shaft

until you begin to engage the coupler threads. (Fig. 5)

9. Secure the shaft using an appropriate size wrench and tighten to 40

to 60 ft-lbs. (Fig. 6)

Figure 1 - Remove Existing Stub-

Shaft

Figure 6 - Tighten the 40 mm Conversion

Shaft

Figure 5 - Rotate to Engage

Coupler Threads

Figure 4 - Coupler Tightened

Figure 3 - Install the Coupler

Figure 2 - Clean the Motor Shaft