COATS Hubnut Removal User Manual

85000228 00 05/06 © COPYRIGHT 2006 ALL RIGHTS RESERVED PRINTED IN U.S.A.

Failure to properly remove the XR hubnut
from the balancer shaft may result in its
premature wear, damage to its threaded
jaw/internal diameter and/or even the
balancer shaft.

To prevent premature wear and to extend its ser­vice life, use the following techniques when remov­ing the XR hubnut.

Releasing XR Hubnut

1. First, manually unscrew the XR hubnut one full

turn, figure 1.

Figure 1 - Unscrew One Full Turn

2. Next, press the release to retract the threaded

jaw inside the XR hubnut, figure 2.

Figure 2 - Release Threaded Jaw

Sliding XR Hubnut

3. Now, hold the release and slide the XR hubnut

off the balancer shaft.

Important: Before removing or installing the XR

hubnut, be sure the threaded jaw is fully disengaged
by pressing and holding hubnut release, figure 3.

Figure 3 - Threaded Jaw Disengaged

XXRR HHuubbnnuutt RReemmoovvaall IInnssttrruuccttiioonnss

COATS, Inc. • Hennessy Industries • 1601 J.P. Hennessy Drive, LaVergne, TN 37086-3565

[phone] • [phone] • [phone] FAX • www.ammcoats.com

XR Hubnut

Threaded

Jaw

Retracted

Manually

Unscrew

One Full Turn

Press XR

Hubnut

Release

CAUTION