COATS Hood Installation

Hood Installation Instructions
for the COATS 950 ProRacer

COATS, Inc. • Hennessy Industries • P.O. Box 3002, 1601 J.P. Hennessy Drive, LaVergne, TN 37086-1982

[phone] • [phone] • [phone] FAX

Part

Item No. Qty. Description

1 308060 1 Hood
2 112843 1 Hood Bar
3 106301 6 1/4-20 Self Tap Screw
4 308062 1 Hood Spring
5 309008 1 Hood Stop
6 301120 1 1/2-13 x 2.25 Bolt
7 301121 4 1/2 Flat Washer
8 301122 1 1/2-13 Nyloc Hex Nut

9 307014 2 Flanged Bearing
10 109944 1 Hood Bar Washer
11 109945 1 Retainer
12 109949 1 Cap Plug
15 112963 1 Hood Bracket
16 106302 4 3/8-16 Bolt
17 106303 4 3/8-16 Wiz Lock Nut

1. Assemble the hood to the hood bar using the six

1/2-20 self tapping screws.

2. Bolt the hood bracket to the balancer, Using the

four 3/8-16 bolts, and the four 3/8-16 wiz lock nuts.

3. Install the hood stop, if not already pre-assembled,

onto the hood bracket.

4. Slide one flanged bearing onto the hood bar; flange

to cam.

5. Install the hood assembly to the hood bracket.

6. Slide the other flanged bearing into position fol-

lowed by the hood bar washer, retainer and cap plug.

7. Raise the hood all the way and verify that the hood

stop bracket on the side of the hood contacts the rub­ber hood stop solidly. Lower the hood and verify that

8112962 4/00 rev.1 © COPYRIGHT 2000 HENNESSY INDUSTRIES AND COATS ALL RIGHTS RESERVED PRINTED IN U.S.A.

the other end of the hood stop bracket contacts the rub­ber hood stop solidly.

8. Raise the hood and hold it up.

CAUTION

Use help to hold the hood while attaching
the hood spring. Attaching the spring with­out holding the hood in place may cause it
to snap open suddenly, resulting in personal
injury.

9. Hook the other hook end of the hood spring under

the balancer.

10. Hook the hood spring over the pin in the rear of

the hood stop bracket. Make sure the spring fits into
the grove in the pin.