Polarizer (CF side) Super Wide View Anti-glare coating, 709.7(H) x 405(W)
Polarizer (TFT side) Super Wide View, 709.7(H) x 405(W).
www.panelook.com
Issued Date: Feb., 13, 2009
Model No.: V315B6-P01
Approval
1366
768
(Typical value measured at CMO’s module: V315B6-L01)
(Typical value measured at CMO’s module: V315B6-L01)
G=0.278, 0.597
B=0.145, 0.068
W=0.285, 0.293
(Typical value measured at CMO’s module: V315B6-L01)
5.8%Typ.
(Typical value measured at CMO’s module: V315B6-L01)
Hardness:2H
1.3 MECHANICAL SPECIFICATIONS
Item Min. Typ. Max. Unit Note
Weight 1150 g I/F connector mounting
position
Note (1) Please refer to the attached drawings for more information of front and back outline dimensions.
(2) Connector mounting position
The mounting inclination of the connector makes
the screen center within ±0.5mm as the horizontal.
+/- 0.5mm
4
(2)
Version2.0
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
www.panelook.com
Global LCD Panel Exchange Center
www.panelook.com
Issued Date: Feb., 13, 2009
Model No.: V315B6-P01
Approval
2. ABSOLUTE MAXIMUM RATINGS
2.1 ABSOLUTE RATINGS OF ENVIRONMENT (BASED ON CMO MODULE V315B6-L02)
Item Symbol
Storage Temperature TST -20 +60 ºC (1), (3)
Operating Ambient Temperature TOP 0 50 ºC (1), (2), (3)
Altitude Operating A OP 0 5000 M (3)
Altitude Storage A ST 0 12000 M (3)
Note (1) Temperature and relative humidity range is shown in the figure below.
(a) 90 %RH Max. (Ta
(b) Wet-bulb temperature should be 39 ºC Max. (Ta > 40 ºC).
(c) No condensation.
Љ 40 ºC).
Relative Humidity (%RH)
100
90
80
Min. Max.
Value
Unit Note
Note (2) The maximum operating temperature is based on the test condition that the surface temperature
of display area is less than or equal to 65 ºC with LCD module alone in a temperature controlled
chamber. Thermal management should be considered in your product design to prevent the
surface temperature of display area from being over 65 ºC. The range of operating temperature
may degrade in case of improper thermal management in your product design.
60
40
20
10
Operating Range
Storage Range
Temperature (ºC)
8060-20 400 20-40
Note (3) The rating of environment is base on LCD module. Leave LCD cell alone, this environment condition
can’t be guaranteed. Except LCD cell, the customer has to consider the ability of other parts of LCD
module and LCD module process.
5
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
Version2.0
www.panelook.com
Global LCD Panel Exchange Center
2.2 ABSOLUTE RATINGS OF ENVIRONMENT (OPEN CELL)
Storage Condition: With shipping package.
www.panelook.com
Issued Date: Feb., 13, 2009
Model No.: V315B6-P01
Approval
Storage temperature range: 25±5
Storage humidity range: 50±10%RH
Shelf life: a month
2.3 ELECTRICAL ABSOLUTE RATINGS
2.3.1 TFT LCD OPEN CELL
Item Symbol
Power Supply Voltage Vcc -0.3 13.0 V
Input Signal Voltage VIN -0.3 3.6 V
Note (1) Permanent damage to the device may occur if maximum values are exceeded. Functional
operation should be restricted to the conditions described under normal operating conditions.
к
Value
Min. Max.
Unit Note
(1)
6
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
Version2.0
www.panelook.com
Global LCD Panel Exchange Center
3. ELECTRICAL CHARACTERISTICS
www.panelook.com
Issued Date: Feb., 13, 2009
Model No.: V315B6-P01
Approval
3.1 TFT LCD OPEN CELL
Parameter Symbol
Ta = 25 ± 2ºC
Value
Min. Typ. Max.
Unit Note
Power Supply Voltage VCC 11.4 12.0 12.6 V (1)
Power Supply Ripple Voltage VRP - - 100 mV
Rush Current I
- - 3.9 A (2)
RUSH
White - 0.45 0.52 A
Power Supply Current
Differential Input High
LVDS
Interface
Threshold Voltage
Differential Input Low
Threshold Voltage
Common Input Voltage V
Terminating Resistor R
Black - 0.33 - A
Vertical Stripe
ICC
(3)
- 0.45 - A
- - +100 mV
V
LVT H
-100 - - mV
V
LVTL
1.125 1.25 1.375 V
LVC
- 100 - ohm
T
Input High Threshold Voltage VIH 2.7 - 3.3 V CMOS
interface
Input Low Threshold Voltage V
0 - 0.7 V
IL
Note (1) The module should be always operated within above ranges.
Note (2) Measurement Conditions:
+12.0V
Q1 Si4435DY
FUSE
R1
1K
C3
1uF
Vcc
(LCD Module Input)
VR1
(Low to High)
(Control Signal)
SW
R2
1K
47K
Q2
2N7002
C1
0.01uF
Vcc rising time is 470us
+12V
0.9Vcc
0.1Vcc
GND
470us
7
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
Version2.0
www.panelook.com
Global LCD Panel Exchange Center
Note (3) The specified power supply current is under the conditions at Vcc =12V, Ta = 25 ± 2 ºC, fv = 60
Hz, whereas a power dissipation check pattern below is displayed.
www.panelook.com
Issued Date: Feb., 13, 2009
Model No.: V315B6-P01
Approval
a. White Pattern
Active Area
c. Vertical Stripe Pattern
b. Black Pattern
Active Area
R
G
R
B
G
B
B
R
R
G
G
B
B
R
R
Active Area
B
RR
G
G
B
B
R
G
G
B
B
R
8
One step solution for LCD / PDP / OLED panel application: Datasheet, inventory and accessory!
Version2.0
www.panelook.com
Loading...
+ 16 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.