T909
INSTALLATION GUIDEINSTALLATION GUIDE
1. DISASSEMBLE
a.
With the supplied Allen wrench, loosen the 2 set screws located on the outer plate.
SET SCREW
Included Items:
• Camera x 1
• Allen Wrench x 2
• Instructions x 1
• Phillips Head Screws x 3
b.
Carefully seperate the mounting plate from the outer plate and camera body.
MOUNTING PLATE CAMERA BODY OUTER PLATE
Required Items:
• Phillips Head Screwdriver
Optional Items:
• CE-REMOTE
• Drill w/ Phillips Head Bit
2. CAMERA MOUNTING
Ax the mounting bracket to the surface with the 3 supplied Phillips head screws. Feed the cable from the camera through the center of the mounting plate. Make connec-
3. ATTACH CABLES
tions to the BNC cable and the power connection. Feed any cable slack into the
mounting surface.
POWER CONNECTION
TO DVR/MONITORTO CAMERA
BNC CONNECTION
To ensure quality operation, verify proper BNC and power termination; along with proper
voltage at camera.
4. REASSEMBLE
a.
Place the camera body into the socket of the mounting plate. Then place the outer
plate over the camera body and mounting plate. Loosely tighten the set screws to hold
the camera together.
b.
Remove the protective film over the lens.
The set screws will be tightened after camera adjustments are made.
Clinton Electronics
*Information in this document is subject to change
v.05.29.13
5. CAMERA ADJUSTMENT
a.
Camera plate rotation can be adjusted by turning the camera to the desired location.
360°
c.
Barrel rotation can be adjusted by rotating the camera body to the desired location.
b.
Lens angle can be adjusted by tilting to the desired location.
180°
Take notice of location of cable exiting the back of the camera body. Depending on angle
of lens there is potential for stretching or pinching of cable. Rotate camera body or outer
plate as necessary.
d.
After camera adjustments have been made, tighten the set screw to lock in
adjustments.
360°
6. REMOTE CONTROL 7. ZOOM/FOCUS ADJUSTMENT
To test the camera with a test monitor first remove the cap located on the underside of
the camera. Plug the *CE-REMOTE into the OSD connection, and connect your test
monitor to the BNC connection located on the *CE-REMOTE cable.
To adjust the zoom or focus of the camera, first loosen the appropriate set screw with the
supplied Allen wrench.
To widen the viewing angle, rotate the Zoom collar to the Left. To narrow the viewing
angle rotate the ZOOM collar to the Right. Rotate the Focus collar Left or Right to focus
the lens.
SET SCREW
OSD CONNECTION
Refer to OSD Manual for detailed instructions on adjusting camera settings.
*CE-REMOTE sold separately.
Clinton Electronics
*Information in this document is subject to change
FOCUS
SET SCREW
After adjustments have been made tighten the Allen screws to lock the adjustments into
place and replace the cap on the underside of the camera.
ZOOM
v.05.29.13
Loading...