Clifford 28 User Manual

AMX28 Immobilizer Owner’s Manual

Your AMX28 Immobilizer includes two coded transponder tags. Keep only one coded tag on your key chain at a time. The second coded tag can be used

as a spare, or for a second driver with their own set of keys. In order to start your vehicle, a coded tag must be attached to the key chain.

Up to five Prime transponder tags can be added to your AMX28 Immobilizer.

Operating Your AMX28 Immobilizer

Activation

1. Turn the ignition key to the "OFF" position and remove the keys. The LED Status Indicator will illuminate solid red.

2. When you open the driver door, the LED will begin to flash slowly to indicate the Immobilizer is armed.

3. If you do not immediately open the driver door, after 20 seconds, the LED will begin to flash slowly to indicate the Immobilizer is armed. While armed, the vehicle cannot be started without the coded tag.

Deactivation

1. With the coded tag on your key chain, turn the ignition key to the "ON" position.

2. The LED will turn off and the engine can now be started.

NOTE: If the LED changes to a rapid flash and the engine will not start, hold the coded tag near the ignition switch to disarm the system.

Valet Mode

To prevent an unauthorized person from entering programming mode and possibly adding their own coded tag, you can put the AMX28 into Valet Mode. In Valet Mode, a valet attendant or service personnel can start the vehicle while you keep the coded tag in your possession.

To Turn On Valet Mode

1. Turn the ignition key to the "ON" position with the doors closed.

2. Open and close the driver door.

3. Turn the ignition key OFF and then ON three times (OFF, ON, OFF, ON, OFF, ON). The LED will flash at a medium rate to indicate the AMX28 is in Valet Mode.

4. Remove the coded tag from your key chain.

To Turn Off Valet Mode

1. Connect the coded tag to your key chain.

2. Turn the ignition key to the "ON" position.

3. Open and close the driver door.

4. Turn the ignition key OFF and then ON three times (OFF, ON, OFF, ON, OFF, ON). The LED will turn off to indicate the AMX28 is out of Valet Mode.

Adding/Deleting Coded Transponder Tags

1. Enter the vehicle and close the door.

2. Disarm the Immobilizer. (Turn the ignition key ON with your coded tag on the key chain.)

3. Remove all transponder tags from the key ring.

4. Turn the ignition key ON, OFF, ON, OFF and then ON. The LED will begin to flash rapidly to indicate the AMX28 is now in the programming mode.

5. Hold one of the transponder tags close to the ignition switch. The LED will change from a rapid flash to slow single flashes to indicate the AMX28 has learned the one transponder tag. Remove the coded tag from the ignition switch area.

6.Hold the second transponder tag close to the ignition switch. The LED will flash slowly two times to indicate the second transponder has been learned and that there are now two transponder tags in memory.

7. Repeat steps 3 and 4 for any other transponder tags you wish to add to the AMX28 memory. (You can add up to 5 tags.)

8.When you have finished adding the transponder tags into memory, turn the ignition key to the "OFF" position to exit programming.

NOTE: Any transponder tag(s) that were not used in this process will be automatically deleted from the AMX28 memory and cannot be used to deactivate the Immobilizer.

Part Number: 31-3325